2.Set CALIBRATION/FS/SWR to CALIBRATION/FS.
3.To calibrate the meter, have your helper select a channel or frequency on your transmitter and hold down its trans- mit key. Tell the helper not to speak into the microphone.
Then, while the helper holds down the transmit key, walk around inside the marks you made using the steps in “Preparing the Antenna Site” on Page 11, covering as much area inside the circle as you can. As you walk, watch the meter’s needle. If it moves to the right of 5 on the FIELD STRENGTH scale, rotate the knob on the front of the meter until the needle lines up with 5 on the scale.
Notes:
•If you use a CB that has sideband modes (SSB), do not select any of these modes. (Use only AM for field strength measurements).
14