Pioneer GEX-AIRWARE1 manual If this happens You should

If this happens:	You should:
There is no power, or your	Insert your AirWare into its home
AirWare shuts off quickly.	docking station and plug the AC
	adaptor into the wall to charge the
	battery. Your AirWare’s battery is low
	(see page 14).
You do not receive all XM	Contact XM Satellite Radio
channels you have subscribed	Your AirWare may not be activated
to.	(see page 16).
Audio sounds distorted	Reduce audio output level
when using the built-in FM	(see page 22).
transmitter.
Audio is too soft when using	Increase audio output level
the built-in FM transmitter.	(see page 22).
No audio when using the	Check to see if you have plugged
home docking station that is	the AC adaptor into the home
connected to a stereo system.	docking station. The audio line
	output only works when the AC
	adaptor is plugged in.
You cannot tune to a	Check that you have not chosen to
channel.	skip that channel (see page 28). If
	the problem persists, contact XM
	Satellite Radio at 1.800.967.2346.
	Verify that you are authorized to
	receive that channel as part of your
	XM subscription, and that you have
	not asked XM Satellite Radio to
	block that channel.
No song title or artist	Nothing is wrong with your AirWare.
name displayed.	That information may be in the
	process of being updated. On some
	sports and news channels, there is
	no title or artist information.
No audio when listening	Make sure that the FM radio and
through an FM radio.	your AirWare are set to the same
	frequency (see page 25).
Audio has static while	Change to another FM frequency
listening through an	(see page 25). If the problem
FM radio.	persists and you are using the
	wireless FM transmitter in a
	vehicle, change to a hard-wired
	FM transmitter (see page 31).
Audio on XM Instant	Nothing is wrong with your AirWare.
Traffic and Weather	These channels use a different
channels sounds different	audio technology than the other
from other XM channels.	XM channels.

If this happens:	You should:
Your AirWare’s controls do	Check whether the lock indicator
not respond.	is being displayed. If so, unlock the
	controls by pressing and holding
	the “mute/pause/lock” button
	until the lock indicator disappears
	(see page 35).
	If you have unlocked the controls
	and they still do not respond, reset
	your AirWare by carefully inserting the
	tip of a paper clip into the “RESET”
	hole under the battery cover.
	You can also reset your AirWare by
	removing and reinserting the
	battery.
The display does not	Reset your AirWare by following the
change or the backlight	procedure above.
does not turn on or
turn off.
Battery level meter doesn’t	Fully charge the battery, then
match the charging or	use your AirWare until the battery
expected playback time.	is fully exhausted. This calibrates
	the battery level meter.

40 41