Philips BDL3245E Mounting in Portrait Position, How to use the logo guider for portrait position

BDL3245E / BDL4245E / BDL4645E

1.6.Mounting in Portrait Position

This display can be installed in portrait position.

1.Remove the table stand, if attached.

2.Rotate 90 degrees clockwise.The “” logo should be on the LEFT side when facing the display.

90

90

1.6.1. How to use the logo guider for portrait position

1. Put the guider on the lower-left corner of the front bezel of the display.	1	2	3
Fold down both of its edges.

2. Peel off the protective film at the back of the “ ” logo sticker.

Hold and press the guider with your left hand. Put the “ ” logo sticker with its adhesive side down into the logo hole with your right hand, and press to make it stick tightly onto the front bezel.

3. Remove the guider.

1.6.2. How to remove the logo

1. Prepare a piece of paper with a cutting area of logo as a protector to	1	2	3
prevent the front bezel from scratching.

2. Using a knife, carefully remove the logo sticker with the paper placing beneath.

3. Tear off the logo sticker.

NOTE: When installing the display on a wall, please consult a professional technician for proper installation.We accept no liability for installations not performed by a professional technician.

4