Philips BDL4245E, BDL3245E, BDL4645E user manual Audio menu, PIP menu

BDL3245E / BDL4245E / BDL4645E

4.2.3. Audio menu

PIP

Select the PIP (Picture-in-Picture) mode.

Picture

Screen

Audio

PIP

Configuration1

Configuration2

Advanced option

Balance

Treble

Bass Volume Maximum volume Minimum volume Mute

Audio source Audio reset Card OPS audio

The options are: {Off} / {PIP} / {POP} / {PBP aspect} / {PBP full}.

PIP input

Select the input signal for the sub-picture.

PIP change

Enlarges the smaller picture to become the main picture, and vice versa.

PIP size

Select the size of the sub picture in the PIP (Picture-in-Picture) mode. The options are: {Small} / {Medium} / {Large}.

PIP audio

Select the audio source in the PIP (Picture-in-Picture) mode.

Balance

Adjust to emphasize left or right audio output balance.

Treble

Adjust to increase or decrease higher-pitched sounds.

Bass

Adjust to increase or decrease lower-pitched sounds.

Volume

Adjust to increase or decrease the audio output level.

Maximum volume

Adjust your own limitation for the maximum volume setting.This stops the volume from being playing at too loud a level.

Minimum volume

Adjust your own limitation for the minimum volume setting.

Mute

Turn the mute function on/off.

Audio source

Select the audio input source according to the audio signal source connected to the audio input and HDMI sockets on the display.

The options are: {HDMI} / {Audio1} / {Audio2} / {Audio3}.

Audio reset

Reset all settings in the Audio menu to factory preset values.

Card OPS audio

Select the analog or digital audio mode for card OPS.

4.2.4. PIP menu

Picture	PIP
	PIP input
Screen	PIP change
Audio	PIP size
	PIP audio
PIP	PIP reset
Configuration1
Configuration2
Advanced option

•{Main} - Select audio from the main picture

•{Sub} - Select audio from the sub picture.

PIP reset

Reset all settings in the PIP menu to factory preset values.

NOTES:

•The PIP function is available only for certain signal source combinations as shown in the table below.

•The availability of the PIP function will also depend on the resolution of the input signal being used.

Main Picture	DVI	VGA	HDMI	YPbPr	S-Video	Video	Card
Sub Picture							OPS
DVI	X	X	X	X	O	O	X
VGA	X	X	X	X	O	O	X
HDMI	X	X	X	X	O	O	X
YPbPr	X	X	X	X	O	O	X
S-Video	O	O	O	O	X	X	O
Video	O	O	O	O	X	X	O
Card OPS	X	X	X	X	O	O	X

(O: PIP function available, X: PIP function unavailable)

By pressing the [PIP ON/OFF] button on the remote control, you can change the mode in the order shown below:

PIP POP PBP aspect PBP full Off

The resolutions in the PIP and POP modes are configured as follows:

PIP SIZE	{Small}	: 320 x 240 pixels
	{Medium}	: 480 x 320 pixels
	{Large} : 640 x 480 pixels
POP SIZE: 474 x 355 pixels
NOTE:	The images displayed in the sub picture always fit the PIP
	sizes shown above irrespective of the aspect ratio of the input
	image.

17