Multiquip Model WM45H manual Basic engine, Muffler Used to reduce noise and emissions

Basic engine

Figure 3. Engine Controls and Components

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions and details of operation and servicing. Fuel Filler Cap — Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

DANGER

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

1.Fuel Filler Cap — Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

2.Throttle Lever — Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3.Engine ON/OFF Switch — ON position permits engine starting, OFF position stops engine operations.

4.Recoil Starter (pull rope) — Manual-starting method. Pull the starter grip until resistance is felt, then pull briskly and smoothly.

5.Fuel Valve Lever — OPEN to let fuel flow, CLOSE to stop the flow of fuel.

6.Choke Lever — Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.

7.Air Cleaner — Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter canister to gain access to filter element.

NOTICE

Operating the engine without an air filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

8.Spark Plug — Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch). Clean spark plug once a week.

9.Muffler — Used to reduce noise and emissions.

10.Fuel Tank — Holds unleaded gasoline. For additional information refer to engine owner's manual.

page 14 — WM45H/E PLASTER/MORTAR MIXER • operation and parts manual — rev. #0 (09/27/12)