components
Figure 2. Major Components
Figure 2 illustrates the basic components and controls of the WM45H and WM45E mixer.
1.Lifting Handle Bars — Use these handle bars to lift and maneuver the mixer.
2.Pivot Point/Zerk Fitting — There is, on each end of the mixing drum a zerk grease fitting. These fittings lubricate the dumping mechanism. Lubricate both fittings at least twice a week.
3.Safety Grill — Provided for operator safety.This safety grill is designed to keep hands and solid objects out of the mixing drum when in use.This grill should be closed at all times when mixer is in use. DO NOT remove the grill or grill opening bar. Keep the grill clean by washing it down daily.
4.Mixing Paddles — Used in the mixing of material. This unit uses four different types of paddles to provide a fast uniform mix.
5.Bag Cutter — This feature allows compound mixing bags to be opened easily, therefore allowing the contents of the bag to fall directly into the mixing drum.
6.Engine Cover — Lift this cover to gain access to the engine compartment.
7.Lifting Handle Bars (Engine Side) — Use these
8.Engine ON/OFF Switch — Pull switch outward to start engine. Push inward to stop engine. This feature is on gasoline models only.
9.Tires — Replace tires with the recommended type tire of 12 x 3.
10.Chock Blocks — Place these blocks (not included as part of the mixer package) under each mixer wheel to prevent rolling.
11.Steel Mixing Drum — Mixing materials such as mortar, plaster are to be placed into this drum for mixing. Always clean the drum after each use
12.Dump Handle — Pull this handle downward to dump the contents of the drum. Push the handle upward to return the drum to its vertical position.
WM45H/E PLASTER MORTAR MIXER • operation and parts manual — rev. #0 (09/27/12) — page 13