Transmitter/Receiver, Receiver Learn Button

TRANSMITTER/RECEIVER

The deﬁ nitions below describe the controls and functions of the Miratron Transmitter and Radio Control Receiver.

Transmitter

1.Power On Switch — Place this switch in the ON position to turn on the transmitter. Be sure to place this switch in the OFF position when the system is not in use.

2.Status LED Indicator — Status LED blinks to indicate transmitter is ON and active. LED will double-blink when battery strength is low.

3.E-STOP Switch — When activated will cause the engine stop and all pumping will cease.

4.Belt Clip — If desired the transmitter can be placed on a belt.

5.Pump ON/OFF Switch — Place this switch in the pump ON position to begin pumping. Place the switch in the OFF position to stop pumping.

6.Engine Speed Switch — Place this switch upward to increase engine speed. Place downward to decrease engine speed.

7.Batteries — Transmitter requires four AA 1.5V alkaline batteries. If rechargable batteries are to be used, nickel-metal hydride (NiMH) are recommended.

Receiver (Learn Button)

Transmitter and receiver must be matched as a pair. Perform the procedure listed below to pair the transmitter and receiver.

1.Place the ignition switch in the ON position.

2.Verify that the status LED on transmitter blinks (active).

3.Place the pumping control switch on the control box in the REMOTE ON position.

4.Press and hold the learn button on the RX4 radio control receiver. While

keeping the learn button depressed, toggle the pump ON/OFF switch for 10 seconds.

INSTALLATION/OPERATION MANUAL — REV. #0 (08/19/09) — PAGE 11