Multiquip C30HDG operation manual Radio Control Receiver Mounting, Antenna/Receiver Installation

RECEIVER INSTALLATION

Radio Control Receiver Mounting

1.Drill two 1/4” holes into the control box support panel on the C30HDG as shown in Figure 1.

2.After both holes have been drilled, deburr each hole opening.

3.Using a 1/4-20 x 1-1/4 bolt (2), 1/4 lock washer (2), 1/4 fl at washer (2) and 1/4 nut (2), mount the radio control receiver onto the control box support panel as shown in Figure 1.

4.Connect BNC end of coaxial antenna cable to BNC connector on radio control receiver.

STEP 5

LOCKING

FLANGE

ANTENNARUBBER

GASKET

ANTENNA

END

COAXIAL

CABLE

BNC CONNECTOR

RECEIVER

END

STEP 6

LOCKING

TIGHTEN FLANGE

DATA

CABLE

COAXIAL

CABLE

TIE-WRAP CABLE TIE-WRAP

PADS SERVICE PADS

(OUTSIDE) LOOP (INSIDE)

Figure 1. Antenna/Receiver Installation

PAGE 8 — INSTALLATION OPERATION MANUAL — REV. #0 (08/19/09)