NEC NEAX2400IMX Data Programming Procedure for Add-On Module, Asdt, Pri Pl Tn Pl Stn, Kyn

DATA PROGRAMMING

Data Programming Procedure for Add-On Module

4.Data Programming Procedure for Add-On Module

When assigning Add-On Module data, perform the following procedure. “X” indicates the value should be tai- lored to the existing system.

STEP 1: ASDT

Assign a Dterm to an even-numbered LEN level. (In this example, LV 0 is used.) Assign the Add-On Module to the subsequent odd-numbered LEN level. (In this example LV 1 is used.)

TN	:	X
STN :		201
LEN :		0 0 0 1 0 1	Odd-numbered LEN level
TEC	:	1 2	Fixed
RSC :		X
SFC	:	X

STEP 2: AKYD

Assign Line/Feature access keys to the Add-On Module. The upper 24 Line/Feature access keys be- long to the associated Dterm and the remaining lower 36 Line/Feature access keys belong to the Add-

On Module.

Use the associated Dterm port to assign information for the Dterm and first 24 keys on the ADM.

TN	:	X
STN	:	200
TP	:	1	Buttons 1-39 are assignable
PRI	:	0
PL TN	:	X
PL STN	:	200
S	:	0	= Off Hook Suppression is off
MWD	:	X
LN PRE	:	0	= Prime Line Pickup
KYN	:	1-16	For Dterm
		17-40	Correspond to KYNs (1-24) on the Add-On Module
KY1	:	X
KD	:	X
TN	:	X
STN	:	XXXX
RG	:	X
ICM	:	X
G-ID	:	X

ND-70684 (E)CHAPTER 3

Page 29

Revision 1.0