Remote Control Function
English
REMOTE CONTROL ID FUNCTION
REMOTE CONTROL ID
The remote control can be used to control up to 100 individual MultiSync monitors using what is called the REMOTE CONTROL ID mode. The REMOTE CONTROL ID mode works in conjunction with the Monitor ID, allowing control of up to 100 individual MultiSync monitors. For example: if there are many monitors being used in the same area, a remote control in normal mode would send signals to every monitor at the same time (see Figure 1). Using the remote in REMOTE CONTROL ID mode will only operate one specific monitor within the group (see Figure 2).
TO SET REMOTE CONTROL ID
While holding down the REMOTE ID SET button on the remote control, use the KEYPAD to input the Monitor ID
When 0 is selected or when the remote control is in normal mode, all monitors will be operated.
Monitor ID:1 | Monitor ID:2 | Monitor ID:3 |
Remote works | Remote works | Remote works |
Figure 1
Remote in
Normal mode or the REMOTE ID is set to 0
Monitor ID:1 | Monitor ID:2 | Monitor ID:3 |
TO SET/RESET REMOTE CONTROL MODE
ID Mode - To enter ID Mode press the REMOTE ID SET button and hold down for | Remote does | Remote does Remote works | ||
not work | not work | |||
2 seconds. | ||||
|
|
| ||
Normal Mode - To return to Normal Mode press the REMOTE ID CLEAR button and hold |
|
|
| |
down for 2 seconds. |
|
|
| |
In order for this feature to work properly, the display must be assigned a Monitor ID | Figure 2 |
|
| |
number. The Monitor ID number can be assigned under the MULTI DISPLAY menu in the | Remote set up to | |||
| use REMOTE | |||
OSD (See page 23). | ID:3 |
|
Point the remote control towards the remote sensor of the desired monitor and press the
REMOTE ID SET button. The MONITOR ID number is shown on the display when your remote control is in ID mode.
Use the remote control to operate a monitor that has a specific MONITOR ID number assigned to it.
1.Set the MONITOR ID number for the display (See page 23). The MONITOR ID number can range from
This MONITOR ID number allows the remote control to operate this specific monitor without affecting other monitors.
2.On the remote control, press and hold down the REMOTE ID SET button while using the keypad to input the REMOTE CONTROL ID number
3.Point the remote control towards the remote sensor of the desired monitor and press the REMOTE ID SET button. The MONITOR ID number is shown in red on the display.
If the REMOTE CONTROLID is Ò0Ó, then all displays in range will show their respective MONITOR ID number in red.
If the MONITOR ID number is shown in white on the display, the MONITOR ID number and the REMOTE CONTROL ID are not the same.
This LCD monitor can be controlled via personal computer or wireless remote control using an
MONITOR ID and IR CONTROL
Using one PC or one infrared wireless controller, up to 100 individual LCD monitors can be controlled through a daisy chain via
1.Connect PC and LCD monitors.
Connect a PCÕs
2.Set Monitor ID and IR Control mode.
For proper operation, the Monitor ID should be set in the OSD menu of each monitor that is in the chain. The Monitor ID can be set under the ÒMULTI DISPLAYÓ menu in the OSD. The Monitor ID number can be set within a range from 1 to 100. No two monitors should share the same Monitor ID number. It is recommended to number each monitor in a daisy chain sequentially from 1. The first monitor in the daisy chain is designated as the primary monitor. Subsequent monitors with the chain are secondary monitors.
In the ÒADVANCED OPTIONÓ menu on the first monitor in the
English-27
Downloaded From