Cobra Electronics MRHH475FLTBTEU owner manual Batteries and Charger, Installing the Battery Pack

Page 7

 

 

Batteries and Charger

 

 

 

Installation

 

 

 

 

 

 

 

 

Batteries and Charger

 

 

 

 

 

LiON Battery Pack

The radio is shipped with a sealed lithium-ion (LiON) battery

 

 

pack (P/N CM 110-021) that is rechargeable.

 

 

WARNING

The charger provided for this radio is only to be used to charge the battery pack provided. Do not charge any other type of batteries in the charger as fire, explosion or battery damage will occur. Avoiding extreme room temperatures will also help prolong the life of the battery pack for the radio.

When your rechargeable batteries begin to discharge too quickly, it is time to install a new battery pack. Your radio will also operate with six (6) high-quality AA alkaline batteries, using the included alkaline battery tray.

Install Battery Pack

Installing the Battery Pack

1. Position the battery pack to line up the two (2) external alignment tabs to the alignment slots in the radio.

2.Engage the battery pack into the radio until battery pack is fully seated against the radio housing.

3. Pivot the locking tab up until it snaps into place on the back of the battery pack.

8 English

Installation

Power Sources

Initial Battery Charge

Batteries and Charger

Initial Charge

The Cobra-provided LiON battery pack may be charged at home, in a car or in a boat using the appropriate 12V DC power cord with the charger.

1.Insert one (1) of the power cords into the back of the drop-in charger.

2.Insert the other end of the power cord into the appropriate 12V DC or 220V AC power source. The wall charger should be installed near the equipment and easily accessible.

3.Remove the spacer from the charger and insert the entire radio/battery into the charger. The metal charge contacts on the battery will contact the mating prongs in the charger to transfer the charging current.

4.Observe that the red light on the front of the charger glows to indicate that the battery pack is properly seated and the charger is operating.

5.Allow the batteries to charge for five (5) to six (6) hours before use. The light will change back to green when the battery is fully charged.

WARNING

Only the rechargeable LiON battery pack can be recharged. You MUST use one of the charging devices provided with this radio. Do not substitute any other type of charging adapter or charger base for this radio. Battery damage, fire or explosion may result. It is equally important to prevent the lithium-ion (LiON) battery pack from freezing to obtain best performance from the battery pack.

NOTE

If the drop-in charger is used on a boat, Cobra recommends you attach it to a horizontal shelf or vertical bulkhead (using the screw holes provided) to prevent possible damage due to the boat rolling or pitching. The charging base has been designed to hold the battery pack in place during rough sea conditions.

Nothing Comes Close to a Cobra® 9

Image 7
Contents Our Thanks to You Customer Assistance For Warranty, Product Service Accessory InformationCustomer Assistance Backlit LCD Liquid Crystal Display Screen Radio Controls IndicatorsBacklit LCD Screen Product Features Product FeaturesTable of Contents Important Safety Information Important Safety Information General PrecautionsLicensing Information Marine Communication VHR Marine Radio ProceduresBelt Clip Included in this PackageWrist Strap and Belt Clip Wrist StrapBatteries and Charger Installing the Battery PackBatteries and Charger Initial ChargeMaintaining the Battery Charge To Remove Battery Pack from RadioAlkaline Batteries Radio Speaker and Microphone Getting StartedCommon Radio Functions Getting StartedChannel Up/Down Buttons Backlight/Key Lock ButtonTo Display the Backlight Momentarily Key LockTo Toggle Between H-M-L Power Modes Setup Mode ProgrammingSetup Mode Programming High/Medium/Low H-M-L Power ButtonTo Set Channel Map Operating Area Squelch ControlTo Set Squelch Control International/Canada/USA Channel MapsBluetooth Mode Pairing Programming To Change Between VOX On and Off Bluetooth Mode Pairing and ProgrammingBluetooth Mode Programming Call Tone Select Ring TonesAtis ID Programming Bluetooth Radio On/OffTo Set Bluetooth On and Off Atis ID ProgrammingStandby/Receive Transmit Marine Standby and Receive Rx ModeChannel 16 Mode Tri-Watch ModeTri-Watch mode Using Tri-Watch Tri-Watch Scan Mode Memory Location ModeTo Program Memory Locations To Erase Stored Memory Locations Channel Scan ModeTo Exit Memory Location Mode To Recall a Stored Memory LocationRewind Operation Memory Location Scan ModeMarine Standby mode Using Rewind-Say-AgainTMTo Answer and End an Incoming Call Using Rewind-Say-AgainTMto Record Audio TransmissionMobile Phone Operation Answer Incoming Phone CallsSimply dial a number on your mobile phone Using Voice DialInitiate a Phone Call To Initiate from the Mobile PhoneGeneral Bluetooth Operation and Frequently Asked Questions To End Pairing At the End of the DayLast Number Redial Floating Radio Floating FeatureMaintenance Troubleshooting Burp FeatureVHF Marine Radio Procedures Voice Calling If You Hear a Distress Call Emergency Messages Distress ProcedureMarine Emergency Signals Emergency Messages and Distress ProcedureSay Marine Distress ProcedureTell where you are Press Talk button and sayLapel Speaker/Microphone SpecificationsAccessories Long Life BatteryVHR Marine Channel Assignments VHF Marine Channel Assignments 21A 18A19A 20A66A 63A64A 65A83A 80A81A 82ADeclaration of Conformity Declaration of Conformity CE MarkingsCE Marking

MRHH475FLTBTEU specifications

The Cobra Electronics MRHH475FLTBTEU is a remarkable handheld VHF marine radio designed for boaters who prioritize safety and communication while on the water. With its advanced features and robust design, this radio is an essential tool for navigating the challenges of maritime environments.

One of the standout features of the MRHH475FLTBTEU is its dual and tri-watch capabilities. This allows users to monitor emergency channels while simultaneously keeping an eye on other important frequencies. The device seamlessly switches between channels, ensuring boaters never miss critical communications. The inclusion of the NOAA Weather Radio provides real-time updates on weather conditions, helping sailors stay informed about any potential storms or hazardous conditions.

The MRHH475FLTBTEU boasts an impressive 6-watt transmit power, which enhances its range and clarity. This is particularly important for emergencies, where clear communication can be the difference between safety and distress. The unit is also equipped with a built-in noise-canceling microphone that significantly reduces background noise, allowing for clearer conversations even in windy or choppy conditions.

In terms of design, the Cobra MRHH475FLTBTEU is rugged and waterproof, meeting JIS7 standards. This means it can withstand immersion in water, making it reliable for any marine environment. The backlit LCD display is easy to read in low-light conditions, displaying relevant information such as signal strength and battery life.

Another notable characteristic is the radio's rechargeable lithium-ion battery, which provides extended usage without the need for constant replacements. With a battery-saving feature, users can prolong the life of each charge, ensuring that the radio remains operational during long outings.

The Cobra MRHH475FLTBTEU is more than just a communication device; it is equipped with features like a GPS interface that provides location information for easier navigation. This integration enhances safety by allowing users to share their coordinates with other vessels in case of emergencies.

Overall, the Cobra MRHH475FLTBTEU is a powerful and versatile marine radio that combines essential safety features with reliable communication technologies. Its durability, advanced functionalities, and user-friendly design make it an invaluable asset for any boater, ensuring peace of mind out on the water. Whether for leisure or emergencies, this radio stands out as a critical piece of equipment for maritime adventures.