Cobra Electronics MRHH350FLT owner manual Channel Scan Mode, To Recall a Stored Memory Location

Page 18

Operating Your Radio

MEM Icon

GMRS

R VHF

T X

A

B U I C

ATIS VOX LOMEDHISAMEMEM

Advanced Operation

To Recall a Stored Memory Location:

1.Press the MEM/ESC button. The MEM icon will be turned On.

2.Press the Channel Up/Down button to select the memory location. If a memory location has been programmed, its associated channel will display on the LCD. Your radio is now in Marine Standby mode on the selected memory location.

To Exit Memory Location Mode:

Press the MEM/ESC button to return the radio to Marine Standby mode. The last channel used in Marine Standby mode will now be displayed on the LCD and the MEM icon will disappear.

To Erase Stored Memory Locations:

1.Press and hold the MEM/ESC button for two (2) seconds. The memory location number will be displayed on the matrix and the MEM icon will be turned On.

2.Use the Channel Up/Down button to advance to the memory location you want to erase.

3.Press the MEM/ESC button to select the memory location.

4.Use the Channel Up/Down button to change to the channel to read “00” at the selected memory location.

5.Press the MEM/ESC button to erase that channel.

Repeat steps 2 through 5 to erase as many additional memories as you want.

6.Press and hold the MEM/ESC button for two (2) seconds. This will return the radio to Memory mode.

7.Press and release the MEM/ESC button again to return to Marine Standby mode.

Operating Your Radio

SCAN Button

MEM

ESC

SCAN Icon

R

GMRS

VHF

T X

 

A

B U I C

ATIS VOX LOMEDHISAMEMEM

Channel Up/Down Buttons

FLOATING MARINE HH350

CALL

ENTSETUP

Advanced Operation

Channel Scan Mode

During Channel Scan mode, the radio will rapidly switch from channel to channel through all the channels.

NOTE

The radio must be squelched for Channel Scan mode to function. See page 18 for Squelch procedure.

To Enter Channel Scan:

1.From Marine Standby mode, press the SCAN button. The radio will immediately begin to scan the entire channel map selected in the active channel map. CHANNEL SCAN will display on the matrix.

2.A signal on any channel will stop the scan for 10 seconds to allow you to listen to the traffic on that location. After 10 seconds, the radio will resume scanning.

3.Press the Channel Up/Down button to resume scanning before the 10-second pause has completed or to change the scan direction.

4.To EXIT Channel Scan mode, press the SCAN button again. The SCAN icon will disappear from the LCD and the radio will return to Marine Standby mode.

30 English

Nothing Comes Close to a Cobra® 31

Image 18
Contents For Assistance in the U.S.A Radio Controls IndicatorsOur Thanks to You Customer Assistance For Assistance Outside the U.S.AProduct Features Backlit LCD ScreenBacklit LCD Liquid Crystal Display Screen Table of Contents Safety Training Information Important Safety InformationGeneral Precautions Industry Canada Antenna NoticeStation License FCC Licensing InformationSea Tow Automated Radio Check ARC System Recommendations for Marine CommunicationRadio Call Sign Included in this PackageInternational Station License Included in this PackageInstall/Remove Antenna Installing the Battery PackWrist Strap and Belt Clip Initial Charge To Remove Battery Pack from RadioBatteries and Charger Alkaline BatteriesCommon Radio Functions Maintaining the Battery ChargeGetting Started Getting StartedKey Lock Radio Speaker and MicrophoneTalk Button Channel Up Button Channel Down ButtonHigh/Medium/Low H-M-L Power Button Setup Mode ProgrammingSetup Mode Programming To Toggle Between H-M-L Power ModesUSA/International/Canada Channel Maps Squelch ControlTo Set Squelch Control To Set Channel Map Operating AreaCall Tone Select Roger Beep ModeKey Tone Mode To Set Call ToneMarine Standby and Receive Rx Mode Standby/Receive TransmitStandby/Receive and Transmit Noaa Test Alert System Weather WX Standby ModeNoaa Emergency Weather Alert Noaa Weather Channels and AlertTri-Watch Setup To Program or Edit the Tri-Watch Channels Tri-Watch ModeTo Switch to Channel 16 or Channel Advanced OperationMemory Location Mode To Recall a Stored Memory Location Channel Scan ModeTo Exit Memory Location Mode To Erase Stored Memory LocationsBurp Feature Floating FeatureMemory Location Scan Mode Floating RadioCalling Coast Stations PowerMaintain Your Watch Calling Other VesselsProhibited Communications VHF Marine Radio ProceduresVoice Calling Voice CallingEmergency Messages Distress Procedure Emergency Messages and Distress ProcedureMarine Emergency Signals Marine Distress ProcedureIf You Hear a Distress Call Exclusions This limited warranty does not apply Warranty and Trademark AcknowledgementLimited 3-Year Warranty For Products Purchased In The U.S.AProduct Service Product ServiceSpecifications Specifications TypicalCanal VHF Marine Channel AssignmentsVHF Marine Channel Assignments Canal 22AChannels 13 Channels 24, 25, 26, 27Channels 84, 85, 86, 87, 87A Channels Wx 1 Thru05A 01A04A 07A20A 18A19A 21A61A 25B28B 62A66A Communications in lower Mississippi River80A 78A79A 81AWeather Channel Assignments Weather Channel AssignmentsAsignaciones de canales meteorológicos Optional Accessories AccessoriesDC Charger