Operating Your Radio
MEM Icon 
Advanced Operation
To Recall a Stored Memory Location:
1.Press the MEM/ESC button. The MEM icon will be turned On.
2.Press the Channel Up/Down button to select the memory location. If a memory location has been programmed, its associated channel will display on the LCD. Your radio is now in Marine Standby mode on the selected memory location.
To Exit Memory Location Mode:
Press the MEM/ESC button to return the radio to Marine Standby mode. The last channel used in Marine Standby mode will now be displayed on the LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the MEM/ESC button for two (2) | |
| seconds. The memory location number will start |
| flashing and the MEM icon will be turned On. |
2. | Use the Channel Up/Down button to advance to the |
| memory location you want to erase. |
3. Press the MEM/ESC button to select the memory | |
| location. The memory channel number will stop |
| flashing and the channel number will start flashing. |
4. | Use the Channel Up/Down button to change to the |
Operating Your Radio
Scanning
SCAN Button
SCAN Icon
Advanced Operation
Channel Scan Mode
During Channel Scan mode, the radio will rapidly switch from channel to channel through all the channels.
NOTE
The radio must be squelched for Channel Scan mode to function. See page 18 for Squelch procedure.
To Enter Channel Scan:
1.From Marine Standby mode, press the SCAN button. The radio will immediately begin to scan the entire channel map selected in the active channel map.
The SCAN icon will show on the LCD.
2.A signal on any channel will stop the scan for
10 seconds to allow you to listen to the traffic on that location.
3.Press the Channel Up/Down button to resume scanning the Channel Scan channels or to change the scan direction.
4.To EXIT Channel Scan mode, press the SCAN button again. The SCAN icon will disappear from the LCD and the radio will return to Marine Standby mode.
channel to read “00” at the selected memory |
location. |
5. Press the MEM/ESC button to erase that channel. |
Repeat steps 2 through 5 to erase as many additional memories as you want.
6.Press and hold the MEM/ESC button for two (2) seconds. This will return the radio to Memory mode.
7.Press and release the MEM/ESC button again to return to Marine Standby mode.
Channel Up/Down Buttons
26 English
Nothing Comes Close to a Cobra® 27