Included in this Package
Installation and
Included in this Package
•
You should find all of the following items in the package with your CobraMarine VHF radio:
Transceiver | Transceiver Flush Mount Kit | Transceiver Surface Mount Kit |
Microphone | Mic Mounting Kit | Operating Instruction Manual |
Mounting and
Powering the Radio
Installation and
Mounting and Powering the Radio
•
Before using your CobraMarine VHF radio, it must be installed on your vessel.
Installing Your Radio
Choose a location for your radio where it will be conveniently accessible with the following factors in mind:
■The leads to the battery and the antenna should be as short as possible.
■The antenna must be mounted at least 3 ft (0,9 m) from the transceiver.
■The radio and all speakers need to be far enough from any magnetic compass to avoid deviation due to the speaker magnet.
■There needs to be free air flow around the
Surface Mount
A Surface Mounting kit is included with your CobraMarine VHF radio to allow its installation on almost any flat horizontal surface.
Warning Sticker | Power/Interface Cables |
WARNING
This equipment is designed to generate a digital maritime distress and safety signal to facilitate search and rescue. To be effective as a safety device, this equipment must be used only within communication range of a
NOTE
Cobra Accessory Harness CM
Surface Mounting Kit
Tilt Lock Knobs
To Mount the Transceiver on Almost any Flat Surface:
1.Use the mounting bracket as a template to drill holes for the mounting screws.
2.Attach the mounting bracket to the chosen surface with the mounting bracket screws and washers.
3.Attach the transceiver to the mounting bracket with the Tilt Lock knobs.
4.Tilt the transceiver to a convenient angle and tighten the Tilt Lock knobs.
|
|
|
|
14 English | Nothing Comes Close to a Cobra® 15 |