3Com 5101T-FB-ST, 5101T-FB-SMA, 5101T-FB-FC manual

Page 2

Federal Communications

Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equip- ment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Canadian Emissions Requirements

Cet appareil numérique respecte les limites de bruits radioélec- triques applicables aux appareils numériques de Class A prescrites dans le norme sur le materièl brouilleur : “Appareils Numériques”, NMB-003 édictée par le ministrè des Communications.

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interfer- ence-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Department of Communications.

Page ii

Image 2 Contents
10BASE-FB Transceiver Installation Guide Page VDE Class B Compliance Copyright Statement Table of Contents EEE Version Page Page Preface Intended AudienceThis guide is divided into five sections Transceiver Overview Transceiver Top PanelTransceiver Top Panel Transceiver DIP Switch Settings Switch Setting DescriptionTransceiver Front Panel Transceiver Front PanelTransceiver Rear Panel Fiber link transmit and receive SQE Test PortsTransceiver Rear Panel Alternate Collision Mode Transceiver LED DescriptionsHigh Power PWR SQE TestInstallation Half Step ModeSite Preparation and Placement Unpacking Procedures Verifying Transceiver Switch Settings Transceiver DIP Switch Default SettingsPage Page Connecting to Ethernet V2.0 and Ieee 802.3 Controllers Connecting to Ethernet V2.0 and Ieee 802.3 Repeaters Connecting Fiber Cables Connecting the AUI Cable Verifying Physical Link Operation To verify physical link operationTroubleshooting Status LEDPage Troubleshooting Using the Status LEDs LEDTroubleshooting Using the Status LEDs Troubleshooting Using the Status LEDs Troubleshooting Link Problems Troubleshooting System Problems Excessive CollisionsLate Collisions and Failure to Defer Miscellaneous Errors Signal Differences Transceiver CablesEEE VersionWire Sizes Transceiver Cable Wire Sizes Cable Type Signal Pair Power PairAUI Cable Pinout Chart Cable PinoutsCO-A Troubleshooting Transceiver Cables Symptoms of Faulty Transceiver CablesCauses of Fault Transceiver Cables Specifications Cable RecommendationsGeneral Specifications General SpecificationsOptical Interface Specifications Optical Interface SpecificationsFiber Optic Cable Specifications Transmit Power SpecificationsTransmit Power Fiber Optic Cables CompatibilityAttachment Unit Interface Specifications AUI Specifications