Model NT1 Series | ® |
BATTERY INSTALLATION
Your NAUTICO1 radio operates with either 4 AA alkaline batteries or an optional NiMH battery pack. The belt clip should be removed (see below) to ease installation or removal of the batteries.
To install the batteries:
1.With the back of the radio facing you, remove the belt clip (see diagram below) for easy access, then remove the Battery Cover by pressing down on the top center and sliding it down from the radio.
2.Insert 4 AA batteries observing the polarity as shown. Installing the batteries incorrectly will prevent the radio from operating or may damage the radio.
3.Return the battery cover by sliding it up on the radio. Replace the belt clip, making sure it locks into place.
One Battery inserted in this slot
BATTERY COMPARTMENT
BATTERY COMPARTMENT COVER
Press here and push down to open
BELT CLIP LOCK TAB
BELT CLIP LATCH
INSTALLING THE BELT CLIP
To install the BELT CLIP, slide the clip down into the slot on the back of the radio until the BELT CLIP LATCH clicks. To remove the BELT CLIP, press the LOCK TAB up, then gently pull the belt clip up toward the top of the radio.
Page 6 |
| www.midlandradio.com |