Icom IC-M505 instruction manual DSC Menu Position Reply Ready CLR˘Exit / ENT˘OK

6 DSC OPERATION

When a GPS receiver (NMEA0183 ver. 2.0 or 3.01) is con-

nected, go to step y. Because the following steps (r and t; Current position/time programming) do not appear.

rThe position information appears. Set your position (lati- tude and longitude) data by rotating [CHANNEL].

•Push [16•C] or [DIAL•DUAL/GRP] to move the cursor forward or backward, respectively.

•Rotate [CHANNEL] to edit N; North latitude or S; South latitude when the cursor is on the ‘N’ or ‘S’ position, and W; West longi- tude or E; East longitude when the cursor is on the ‘W’ or ‘E’ po- sition.

•Push [CLR] for 1 sec. to clear the latitude/longitude data.

•Push [CLR] to cancel and return to the DSC menu.

--DSC Menu--

Input Position

Latitude

__°__.___N Null

Longitude

__°__.___W Null

<CLR 1sec˘Null Data>

<CLR˘Exit / ENT˘OK>

tAfter setting the position data, push [CHANNEL•ENTER] to set the current UTC time. Set the current UTC time by rotating [CHANNEL], then push [CHANNEL•ENTER].

•Push [16•C] or [DIAL•DUAL/GRP] to move the cursor forward or backward, respectively.

•Push [CLR] for 1 sec. to clear the UTC time data.

•Push [CLR] to cancel and return to the DSC menu.

--DSC Menu--

Input UTC Time

__:__Null

<CLR 1sec˘Null Data>

<CLR˘Exit / ENT˘OK>

--DSC Menu--

Position Reply Ready

<CLR˘Exit / ENT˘OK>

yPush [CHANNEL•ENTER] to transmit the position request reply call to the selected station.

•Your position data is transmitted, when [CHANNEL•ENTER] is pushed.

--DSC Menu--

Position Reply

Transmitting

38