Operation (Continued)
B. Procedure to Receive
1.Be sure that power source, microphone and antenna are connected to the proper connectors before going to the next step.
2.Turn unit on by turning VOL knob clockwise.
3.Set the VOL for a comfortable listening level.
4.Set MODE switch to the desired operation mode.
5.Listen to the background noise from the speaker. Turn the SQ knob slowly clockwise until the noise just disappear. This SQ is now properly adjusted. The receiver will remain quit until a signal is actually received. Do not advance the control too far, or some of weaker signals will not be heard.
6.Set the CHANNEL switch to the desired channel.
7.Set the RF gain control fully clockwise for maximum RF gain.
C. Procedure to Transmit
1.Select the desired channel of transmission.
2.Set the MIC GAIN to the level that will best suit your individual use.
3.If the channel is clear, depress the
Memo
- 10 - | - 11 - |