ACR Electronics PLB-350B, 2883 GPS acquisition test, Changing ownership or contact information

Page 16

5. GPS acquisition test

This test is NOT required as 100% of all GPS receivers that leave ACR have been tested to ensure they perform correctly. However, if you would like to ensure your GPS receiver is working, please follow these instructions very closely.

CAUTION: The following test should not be performed more than twelve times during the life of the battery pack. Once this GPS testing feature reaches 12 times, the feature will be disabled by internal software until the battery is replaced.

NOTE: The GPS receiver is located under the bottom front portion of the case. It is imperative that the receiver is not obstructed during Self-test or activation to ensure that the GPS receiver is acquiring your latitude (LAT) and longitude (LON) position. This test must be performed outside with a clear view of the sky.

Press the Self-test button for greater than 5 seconds. Observe the beacon for the entire GPS test. A BEEP and green LED will indicate that the GPS has been turned ON. The beacon will BEEP every 5 seconds and the GPS will remain ON until LAT/LON coordinates have been obtained or until 2 minutes have elapsed. If good LAT/LON data has been obtained, a single 406 MHz test signal will be sent out with location data and the GPS will be turned OFF and the green LED will light for at least 3 seconds along with a long beep. This LAT/LON data is not saved for use. The green LED indicates that the GPS is functioning properly and that the beacon is in a location or environment where it can receive the necessary signals from satellites. If the GPS does not acquire good LAT/LON data, the GPS will turn OFF after 2 minutes, followed with a RED LED light up for 3 seconds along with a long beep, and no 406 MHz signal will be sent out.

 

GPS Test Sequences (max. 2

 

 

GPS Test Guide

 

 

minutes 50 seconds)

 

 

 

 

 

 

 

 

 

 

 

Green LED and BEEP at start

 

 

Successfully acquired GPS

 

followed by continuous BEEPS

 

 

 

 

 

data, 406 MHz signal sent out

 

every 5 seconds,

Green LED

 

 

 

 

 

with location data

 

& Long BEEP

 

 

 

 

 

 

 

 

 

 

Green LED and BEEP at start

 

 

 

 

 

followed by continuous BEEPS

 

 

GPS data was not successfully

 

every 5 seconds,

Red LED

 

 

acquired, no signal sent out.

 

& Long BEEP

 

 

 

 

 

6. Changing ownership or contact information

As the owner of the beacon, it is your responsibility to advise the national authority of any change in your registration information. If you are transferring the beacon to a new owner, you are required to inform the national authority. You can do this by using their online database or by

Y1-03-0241A

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Y1-03-0241A Please Read ALL Warnings Table of Contents Step ONE Registering Your Beacon What country should I register in? How do I register?Registration NOAA/NESDIS Suitland Road Suitland, MDStep TWO HOW the Beacon Works How your beacon brings helpInternal GPS position system Anatomy of your beacon Front BackDistinguishing PLB Features Activating your beaconPLB-350B Key Pad Functions406 MHz/121.5 MHz antenna position Activation 406 MHz and 121.5 MHzActivation with GPS GPS receiver orientation GPS Receiver Location Turning off the beaconPreventing false alerts False alertRoutine Maintenance Battery ReplacementStep Three Maintaining Your PLB Self-TestBattery witness seal failure Self-Test Sequences Self-Test GuideGPS Test Sequences max GPS Test Guide Minutes 50 seconds GPS acquisition testChanging ownership or contact information Appendix a Accessories Multi-Function Belt ClipAttachment Clip General overview Appendix B the COSPAS-SARSAT SystemGlobal Positioning System GPS Appendix C Technical Specifications MHz TransmitterLimited Warranty Appendix D WARRANTY, Useful Life POLICY, NoticesUseful Life Policy EC Declaration of Conformity Notified Body

PLB-350B, 2883, 2882 specifications

ACR Electronics is a renowned name in the field of emergency signaling and safety devices. Among its various offerings, the ACR 2882, ACR 2883, and the PLB-350B Personal Locator Beacons (PLBs) stand out due to their advanced features and reliability.

The ACR 2882 and 2883 models are compact and rugged PLBs designed for outdoor enthusiasts, sailors, and adventurers who venture into remote areas. One of their main features is the dual frequency capability, which operates on both 406 MHz and 121.5 MHz frequencies. This dual-frequency technology enhances their effectiveness in emergency situations, ensuring that distress signals can be received by both satellite systems and local search and rescue teams.

Both models are equipped with a high-performance GPS receiver, which significantly improves location accuracy. In challenging environments, where precise positioning is crucial, these PLBs can obtain a location fix quickly and share it with rescue services. The compact design, weighing around 7 ounces, makes them portable enough to carry on any adventure without adding significant weight to your gear.

Battery life is another critical feature of the ACR 2882 and ACR 2883. They utilize a lithium battery that can provide up to 24 hours of continuous operation upon activation. This extended battery life ensures that users have a dependable signal even in prolonged emergencies, and they can be easily tested and replaced when needed.

On the other hand, the PLB-350B stands out with its innovative design and user-friendly interface. It features an intuitive one-button activation system that allows users to signal for help swiftly. Its rugged construction is built to withstand harsh conditions, making it suitable for a variety of outdoor activities like hiking, fishing, or boating.

Additionally, the PLB-350B includes a built-in strobe light, which serves as a visual distress signal, further increasing the chances of rescue. Its battery is designed to last for up to 7 years, offering a reliable solution for safety without frequent maintenance requirements.

Collectively, the ACR 2882, 2883, and PLB-350B represent the cutting edge of personal safety technology. With their advanced communication capabilities, durable design, and user-friendly features, these devices are essential tools for anyone who values safety during outdoor adventures. They provide peace of mind knowing that help is just a button press away, no matter where you find yourself.
Top Page Image Contents