4 | OPERATION |
4.1 INITIAL PROCEDURE
NOTE
Never key the transceiver without an antenna connected. Damage may occur to the transceiver. Do not operate the transceiver while charging.
1.To remove the belt clip, pull the stopper and slide the belt clip upward.
2.Install the nylon carrying strap on the belt clip if desired.
3.Install the battery pack on the transceiver. (see figure 4 and section 5.2)
4.Install the antenna to the transceiver.
| L |
O | |
V |
|
Figure 3. Antenna Installation
5.Turn the POWER SWITCH /VOLUME CONTROL knob clockwise to
turn the transceiver on.
NOTE
Water resistance of the transceiver is assured only when the battery pack and antenna are attached to the transceiver.
Turn the battery lock screw clockwise 1/4 turn to tighten.
OPEN
LOCK
Figure 4. Battery Pack Installation
page 10 | Owner’s Manual | HX260S |