Standard Horizon HX260S owner manual Transmission, Transmit Time OUT Timer TOT

Page 14

4.3 TRANSMISSION

1.Perform steps 1 through 7 of RECEPTION.

2.Before transmitting, monitor the channel and make sure it is clear.

THIS IS AN FCC REQUIREMENT!

3.For communications over short distances, press the H/L key until “L” is displayed on the LCD. This indicates low power, approximately 1 watt.

NOTE

Transmitting on 1 watt prolongs battery life. Low power (1 watt) should be selected whenever possible.

4.If using low power is not effective, select high power (5 watts) by pressing the H/L key until “H” is displayed.

5.When receiving a signal, wait until the signal stops before transmitting. The transceiver cannot transmit and receive simultaneously.

6.Press the PTT (push - to - talk) switch. The TX indicator is displayed during transmission.

7.Speak slowly and clearly into the microphone. Hold the microphone about 1/2 to 1 inch away from your mouth.

8.When the transmission is finished, release the PTT switch.

9.Refer to the OWNER’S MANUAL SUPPLEMENT for standard transceiver operating procedures.

4.4 TRANSMIT TIME - OUT TIMER (TOT)

While the PTT switch is held down, transmission time is limited to 5 minutes. This prevents prolonged unintentional transmissions. About 10 seconds before automatic transmitter shutdown, a warning beep is sounded from the speaker. The transceiver automatically switches to the receiving mode, even if the PTT switch is held down. Before transmitting again, the PTT switch must first be released and pressed again. This time- out timer (TOT) prevents a continuous transmission that would result from an accidentally stuck PTT switch.

page 12

Owner’s Manual

HX260S

Image 14
Contents HX260S Table of Contents FCC Notice FCC/ Industry Canada Information General InformationIntroduction Packing List AccessoriesReplacement Parts OptionsDW KEY Power SWITCH/VOLUME ControlControls and Connections Up KEYControls and Connectors WX KEY Scan KEYL KEY 16/9 KEY Antenna Connector3CNB260 Battery Pack Lamp/key lock KEYIndicators Output Power Indicator Key Lock SymbolLow Battery Indicator Initial Procedure OperationReception Transmit Time OUT Timer TOT TransmissionNoaa Weather Channels USA, CANADA, and International ModeSIMPLEX/DUPLEX Channel USE Weather Alert Memory ScanningOperating on Channel Dual WatchingEmergency Channel Resetting the TRANSCEIVER’S Microprocessor Battery Pack REMOVAL/INSTALLATION BatteryBattery Charging Using Battery Tray Operating CWC260 Battery ChargerBattery Safety Do not Short Battery Pack TerminalsMaintenance Troubleshooting Chart Symptom Probable Remedy CauseReceiver GeneralTransmitter Yaesu U. S. a