IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER &
BATTERY CARTRIDGE
I . SAVE THESE INSTRUCTIONS - This manual
contains important safety and operating instructions for battery charger.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance.
Recycling the Battery
2 . Before using battery charger, read all instructions and cautionary markings |
| The only way to dispose of | a Makita battery is |
|
on (1) battery charger, (2)battery, and (3)product using battery. |
| to recycle it. The law prohibits any other |
| |
3. CAUTION - To reduce risk of injury, charge only MAKITA Battery Cartridge |
| |||
| method of disposal. |
| ||
7000,7001,7002,9000,9001,9002,9100,9101,9101A.9102,9102A. |
|
|
|
|
9122,1200,1201,1201A,I202,1202A, 1210,1211,1222OR 1422. Other | i- | To recycle the battery: |
|
|
types of batteries may burst causing personal injury and damage. |
|
| ||
|
|
|
| |
4. Do not expose charger to rain or snow.
5.Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons.
6.To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
7 . Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
8. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:
a . That pins on plug of extension cord are the same number, size, and shape as those of plug on charger;
b.That extension cord is properly wired and in good electrical condition; and c. That wire size is at least as large as the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
I Length of Cord (Feet) I 25 I 50 I 100 I 150 I
AWG Size of Cord I 18 I 18 I 18 I 16 I
9. Do not operate charger with damaged cord or plug - replace them im- mediately.
IO. Do not operate charger if it has received a sharp blow, been dropped, or other- wise damaged in any way; take it to a qualified serviceman.
1 1 . Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
12.To reduce risk of electric shock, unplug charger from outlet before attempt- ing any maintenance or cleaning. Turning off controls will not reduce this risk.
1 . Remove the battery from the tool.
2. a). Take the battery to your nearest Makita Factory Service Center
or
b). Take the battery to your nearest Makita Authorized Service Center or Distributor that has been designated as a Makita battery recycling location.
Call your nearest Makita Service Center or Distributor to determine the location that provides Makita battery recycling. See your local Yellow Pages under
To maintain product SAFETY and RELIABILITY, repairs, maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
6