ADIC FileServ Version 4.4.1601363 manual Update sysparm File with Media Capacity

Drive Type	Supported	Supported
	on IRIX	on Solaris
Quantum DLT 4000	Yes	Yes
Quantum DLT 7000. Configure this drive as a DLT 4000.
Quantum DLT 8000. Configure this drive as a DLT 4000.
Sony AIT-1 SDX-300	Yes	Yes
Sony AIT-2 SDX-500
Sony GY-10	Yes	Yes
Sony GY-2120
Sony GY-8240.See“Modify IRIX Kernel for SONY DTF-2 Drive” on
page 5 of these"Release Notes."
During initial configuration on VolServ, set these drives up to support
both DTF1 and DTF2 media types.
Storage Technology 4480	Yes	Yes
Storage Technology Timberline 9490-E
Storage Technology 9840
NOTE: To tune the kernel for DST drives, follow the steps below:
Step 1: Login as root.
Step 2: Run systune -i.
Step 3: Enter maxdmasz 513.
Step 4: Enter quit.
Step 5: Reboot the system.

Update sysparm File with Media Capacity

After an initial installation, if you add or change a Sony AIT-2, IBM 3590E1A, Quantum DLT 7000, or Quantum DLT 8000 drive type, update the system parameters to reflect the new media capacity by following the steps below:

Step 1. Log in as root.

Step 2. Edit the fs_sysparms file.

#vi /$FS_HOME/sysparms/fs_sysparms

Step 3. If you are adding an AIT-2 drive, update the DEF_MED_SPC_AIT parameter definition to be as shown below if you are using 170m tape:

DEF_MED_SPC_AIT=35000000000;

Page 4 of 16 FileServ Version 4.4.1—601363 Rev A www.adic.com