6 Installation and Maintenance
Correct installation is critical to the performance of the FISH 4500/4600. There are two compo- nents to install, the display unit and the trans-
ducer. It is vital to read the entire installation section of this manual before attempting to install the components.
6-1 What comes with this product?
Standard configuration:
•FISH 4500/4600 display unit
•Power cable
•Mounting bracket (screws included)
•Warranty registration card
•This manual
•Sun cover for display unit
•Flush mounting kit
•Dual frequency transom transducer (includes cable kit and screws)
•Transom Mount Transducer Installation Manual.
Mounting bracket
| Screws | |||
|
|
|
| |
|
|
|
|
|
Display unit |
| Power | cable | |
|
|
|
| |
Dual frequency |
|
|
|
|
|
|
|
| |
transom transducer |
|
|
|
|
6-2 Options and Accessories
• TRACKER series of chartplotters | |
• Through hull dual frequency transducer | |
• Through hull speed/temperature transducer | |
• Fuel flow kit (single or twin engine) | |
• | Replacement paddle wheel |
• | SmartCraft Gateway |
Please consult your Navman dealer for more information.
• REPEAT 3100 (see section |
several instruments). |
• Diesel 3200 for fuel flow on diesel engines |
TRACKER 5500/5600 chartplotter
Fuel flow kit
6-3 Mounting and removing the display unit
There are two mounting arrangements:
•Flush mounting requires a solid panel with access behind for wiring and mounting screws. After flush mounting, the FISH 4500/4600 cannot be tilted or moved after installation to reduce any unwanted glare or reflections. Carefully select the best viewing position before installation.This would generally be in a shaded area.
•Bracket mounting requires a panel for mount- ing the bracket. Ensure that the panel is not likely to deform and is not subject to excessive vibration. The bracket can be tilted and rotated so the FISH 4500/4600 can be removed after
each use.
Select a position where the display unit will be:
•At least 4” (100 mm) away from the com- pass.
•At least 12” (300 mm) away from any radio transmitter.
•At least 4 ft. (1.2 m) away from any antenna.
•Easy to read by the helmsman and crew
while underway.
•Protected from physical damage during rough sea passages.
•Easy to access the 12/24VDCpower source.
•Convenient to route the transducer cables.
Flush Mounting
1. Cut a hole in the bulkhead for the display unit using the flush mount template.
2. Drill four holes for the mounting studs using the flush mount template.
3. Screw the four studs into the brass inserts in the back of the display unit.
4. Sit the display unit in place and fit the washers and nuts to the studs.
Bracket Mounting
1. Fix the mounting bracket onto the boat using the threestainlesssteelscrews.Donotovertightenthe screws, as the bracket may not rotate.
2. Push the display unit onto the mounting bracket and tighten it firmly using the knob on the mounting bracket.
3. Attach the cables.
FISH 4500/4600 Installation and Operation Manual | NAVMAN | 27 |