Eagle Electronics 250 DS, 250 DF manual Transom Transducer Assembly and Mounting

Page 15

Third, a transducer CAN NOT shoot through wood and metal hulls. Those hulls require either a transom mount or a thru-hull installation.

Fourth, if your Skimmer transducer has a built in temp sensor, it will only show the temperature of the bilge, not the water surface temp. Follow the testing procedures listed in the shoot-thru-hull installation section at the end of this instruction booklet to determine if you can satisfactorily shoot through the hull.

Transom Transducer Assembly and Mounting

The best way to install the transducer is to loosely assemble all of the parts first, place the transducer's bracket against the transom and see if you can move the transducer so that it's parallel with the ground.

1.Assembling the bracket. Press the two small plastic ratchets into the sides of the metal bracket as shown in the following illustration. Notice there are letters molded into each ratchet. Place each ratchet into the bracket with the letter "A" aligned with the dot stamped into the metal bracket. This position sets the transducer's coarse angle adjustment for a 14° transom. Most outboard and stern-drive transoms have a 14° angle.

Dot

Align plastic ratchets in bracket.

2.Aligning the transducer on the transom. Slide the transducer between the two ratchets. Temporarily slide the bolt though the transducer assembly and hold it against the transom. Looking at the transducer from the side, check to see if it will adjust so that its face is parallel to the ground. If it does, then the "A" position is correct for your hull.

11

Image 15
Contents FishEasy 250 DS & SeaFinder 250 DF Copyright 2006 LEI-Eagle All rights reserved Table of Contents Troubleshooting General IntroductionZoom bottom track Back-up memorySonar Automatic rangingHow Sonar Works Preparations Dual Search & Dual FrequencyPage Page Recommended Tools and Supplies Section Installation & AccessoriesSelecting a Transducer Location How low should you go? Shoot-thru-hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Assemble transducer and bracket Bottom Hull Flat-bottom hull Deep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation True bottom Second bottom Manual range setting Transducer location High speed Trolling speed Shoot-thru-hull Installation Power and Cable Connections Page Mounting The Sonar Unit In-Dash or Bracket In-Dash InstallationIn-Dash Template Bracket Installation173.9 137.9 72.9 23.4 157.9 Millimeter 56.9 Inch Portable Installation Portable Transducer Assembly Tie nylon Cord here Suction Portable transducer installed on boat transom Keyboard Basics OperationMemory MenusUP & Down Arrows ↑ ↓ Display Full Chart FasTrack Depth Range Zoom Sensitivity To adjust sensitivity in Manual Mode To adjust sensitivity in Auto ModeGrayline Grayline scroll bar Chart Speed Frequency Fish I.D. Fish arches Fish I.D. symbols FishTrack Alarms Fish AlarmDepth Alarms Shallow Alarm Battery Alarm Deep AlarmNoise Rejection and ASP Noise Rejection menu Temperature Display Depth DisplayTo display Depth To display Temperature To display voltage VoltageUnits BacklightSimulator ContrastSet Language Software InformationTo select a language Reset Options Page Unit turns on only in simulator mode Unit wont turn onUnit freezes, locks up, or operates erratically Page Noise No fish arches when the Fish I.D. feature is offPage Page Page Eagle Electronics Not toll-free How to Obtain Service…Accessory Ordering Information for all countries Visit our web site