Eagle Electronics 250 DS, 250 DF manual Assemble transducer and bracket

Page 17

Metal

Nut washer

Rubber	Metal washer
washers	Metal washer
	Bolt

Assemble transducer and bracket.

4.Drilling mounting holes. Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The transducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view (left) and shown from above (right).

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

13

Image 17

Contents FishEasy 250 DS & SeaFinder 250 DF Copyright 2006 LEI-Eagle All rights reserved Table of Contents Troubleshooting General IntroductionSonar Back-up memoryAutomatic ranging Zoom bottom trackHow Sonar Works Preparations Dual Search & Dual FrequencyPage Page Recommended Tools and Supplies Section Installation & AccessoriesSelecting a Transducer Location How low should you go? Shoot-thru-hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Assemble transducer and bracket Bottom Hull Flat-bottom hull Deep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation True bottom Second bottom Manual range setting Transducer location High speed Trolling speed Shoot-thru-hull Installation Power and Cable Connections Page Mounting The Sonar Unit In-Dash or Bracket In-Dash InstallationIn-Dash Template Bracket Installation173.9 137.9 72.9 23.4 157.9 Millimeter 56.9 Inch Portable Installation Portable Transducer Assembly Tie nylon Cord here Suction Portable transducer installed on boat transom Keyboard Basics OperationUP & Down Arrows ↑ ↓ MemoryMenus Display Full Chart FasTrack Depth Range Zoom Sensitivity To adjust sensitivity in Manual Mode To adjust sensitivity in Auto ModeGrayline Grayline scroll bar Chart Speed Frequency Fish I.D. Fish arches Fish I.D. symbols FishTrack Depth Alarms AlarmsFish Alarm Shallow Alarm Battery Alarm Deep AlarmNoise Rejection and ASP Noise Rejection menu To display Depth Temperature DisplayDepth Display To display Temperature Units VoltageBacklight To display voltageSimulator ContrastTo select a language Set LanguageSoftware Information Reset Options Page Unit freezes, locks up, or operates erratically Unit turns on only in simulator modeUnit wont turn on Page Noise No fish arches when the Fish I.D. feature is offPage Page Page Eagle Electronics Not toll-free How to Obtain Service…Accessory Ordering Information for all countries Visit our web site