Eagle Electronics 250 DF, 250 DS manual Shallow Alarm

Page 52

vessel enters water that is more shallow than the alarm's setting. The deep alarm sounds a tone your vessel enters water that is deeper than the alarm's setting.

Shallow Alarm

To set the shallow alarm depth, repeatedly press MENU until SHALLOW ALARM appears.

Shallow Alarm menu (left). Shallow Alarm Value Dialog box (right).

Press to SET VALUE. The Shallow Alarm Value dialog box will appear. Use ↑ ↓ to enter the first number in the dialog box, then press MENU DOWN to move to the next digit. Repeat those steps until the desired depth has been entered in the dialog box. To move the cursor back to any of the previously entered numbers, press MENU UP. Press PWR to return to the Shallow Alarm menu. Use to select ON, which will turn on the alarm, then press PWR to clear the menu. When your vessel en- ters water more shallow than the alarm’s setting, an alarm will sound and a message will appear on the screen.

If the alarm goes off, press PWR to shut it off. It will remain silent until it is triggered again.

48

Image 52
Contents FishEasy 250 DS & SeaFinder 250 DF Copyright 2006 LEI-Eagle All rights reserved Table of Contents Troubleshooting Introduction GeneralBack-up memory SonarAutomatic ranging Zoom bottom trackHow Sonar Works Dual Search & Dual Frequency PreparationsPage Page Section Installation & Accessories Recommended Tools and SuppliesSelecting a Transducer Location How low should you go? Shoot-thru-hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Assemble transducer and bracket Bottom Hull Flat-bottom hull Deep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation True bottom Second bottom Manual range setting Transducer location High speed Trolling speed Shoot-thru-hull Installation Power and Cable Connections Page In-Dash Installation Mounting The Sonar Unit In-Dash or BracketBracket Installation In-Dash Template173.9 137.9 72.9 23.4 157.9 Millimeter 56.9 Inch Portable Installation Portable Transducer Assembly Tie nylon Cord here Suction Portable transducer installed on boat transom Operation Keyboard BasicsMenus MemoryUP & Down Arrows ↑ ↓ Display Full Chart FasTrack Depth Range Zoom Sensitivity To adjust sensitivity in Auto Mode To adjust sensitivity in Manual ModeGrayline Grayline scroll bar Chart Speed Frequency Fish I.D. Fish arches Fish I.D. symbols FishTrack Fish Alarm AlarmsDepth Alarms Shallow Alarm Deep Alarm Battery AlarmNoise Rejection and ASP Noise Rejection menu Depth Display Temperature DisplayTo display Depth To display Temperature Voltage UnitsBacklight To display voltageContrast SimulatorSoftware Information Set LanguageTo select a language Reset Options Page Unit wont turn on Unit turns on only in simulator modeUnit freezes, locks up, or operates erratically Page No fish arches when the Fish I.D. feature is off NoisePage Page Page Eagle Electronics How to Obtain Service… Not toll-freeAccessory Ordering Information for all countries Visit our web site