Raymarine ST40 manual Parts supplied, Speed transducer Supplied with bung not illustrated

Page 9

vi

ST40 Speed Instrument Owner’s Handbook

Parts supplied

ST40

SPEED

ST40 Speed instrument

Gasket

Instrument Cover

1 m (3 ft) power cable

Fixing Thumb

stud nut

Clamping bracket

ST40

Speed

Instrument

Owner's

Handbook

Worldwide Distributors

Speed transducer Supplied with bung (not illustrated)

ST40 Speed Instrument - quick reference guide

Normal operation

SWITCH ON

Last permanent screen is displayed

Current

speed

Maximum

Reset

speed

3 seconds

Average

Reset

speed

3 seconds

Log

Reset

Trip

3 seconds

Water

Temp.

Note:

*denotes temporary screens which will time-out to the previous permanent screen after 5 seconds.

 

 

Adjusting display backlighting/contrast

 

To enter adjust mode, press

for 1 second to adjust BACKLIGHTING and a further 1 second to adjust CONTRAST

OFF

LEVEL 1

LEVEL 2

LEVEL 3

LEVEL 2

LEVEL 1

 

To exit adjust mode press or

or wait for 5 second timeout

 

Owner’s Handbook.

Worldwide Service Centre

Quick Reference Guide

Warranty document and fitting

Handbook.

 

templates included in Handbook

 

 

Note:

The items shown here are supplied for an ST40 Speed system. If an instrument is purchased separately, a transducer is not included. If any item is not present, contact your Raymarine Dealer.

D4570-2

Image 9
Contents Distributed by ST40 Speed Instrument Copyright Raymarine Limited Important information EMC conformanceHandbook information ST40 Speed Instrument Owner’s Handbook Contents Calibration Preface Speed transducer Supplied with bung not illustrated Parts suppliedOperating procedures OperationIntroduction Normal Operation Adjust Backlighting Adjusting display backlighting and contrastST40 Speed Instrument Owner’s Handbook Maintenance and Fault Finding MaintenanceServicing and safety Fault finding No speed or water temperature information Low batteryNo speed Information But water Temperature Information is Display blankAssistance Installation Planning your installationEMC installation guidelines Tools required Suppression FerritesConnections to Other Equipment Site requirements TransducerHull material Transducer type Transducer siting Procedures Fitting transducerInstrument Running transducer cable Connections to the instrumentStand-alone connections SeaTalk connections Fitting the instrumentCut hole Screw stud into instrument Desktop Mounting BracketCalibration requirement ST40 Speed Instrument Owner’s Handbook Calibration User calibrationEMC conformance User Calibration Dealer calibration Intermediate calibrationDealer Calibration Instrument Specification ST40 Speed Instrument Owner’s Handbook Glossary Cal factorResponse ST40 Speed Instrument Owner’s Handbook EMC IndexST40 Speed Instrument Owner’s Handbook ST40 Instrument Template Page Warranty Limitations Limited Warranty CertificateUnited States of America UK, Europe, Middle East, Far East Factory Service Centers
Related manuals
Manual 45 pages 51.08 Kb