Powering Multiple Downriggers

FUSE / BREAKER SPECIFICATIONS:

30 Amp, 32 Volt, waterproof, fast blow.

WIRE SPECIFICATIONS:
0-15 ft.	(0-5 meters)	10 gauge
15-25 ft.	(5-8 meters)	8 gauge
25-30 ft.	(8-9 meters)	6 gauge

CAUTION: When using wire longer than that provided with your unit, follow the above chart. When running more than 30 feet from the battery, contact a qualified electrician.

When operating multiple Mag 20 DTs, run a maximum of 2 downriggers per dedicated battery. The advanced features of the Mag 20 DT can keep the unit working virtually all the time. (See below for the recommended wiring setup.)

NOTE: To ensure proper operation of your Mag 20 DT, ground its battery to your boat’s electrical system’s ground. Malfunctions with the PIC, communication between units, or loss of operation result from faulty grounding. Always check to see if your boat is properly grounded first.

Red ( + )

Black ( – )

Typical Operating Time*:

1 Mag 20 DT per battery – 24 hours.

2 Mag 20 DTs per battery – 10 hours.

*Time based on lab results using a 15lb weight and Deep-Cycle batteries. Actual run time will vary.

Battery

Fuse Holder

Battery	Circuit Breaker
	Red ( - )

Connect

Multiple

Batteries in

Parallel

FOR MAXIMUM PERFORMANCE:

Use Minn Kota Group 27 or 31 sized, Deep-Cycle marine batteries. For extended battery life, add a Minn Kota on-board, DC alternator charger.

WIRING YOUR DOWNRIGGER