Cannon Mag 20 Dt/Hs, Mag 20 Dt/Ts owner manual Short Stop System, Positive Ion Control System

Page 14

THE

The Short Stop System

 

 

 

 

 

The Short Stop system is composed of three

 

 

 

 

 

SHORT

critical components: the electronic unit, the reel set

 

 

 

 

 

 

 

 

 

 

screw, and the trolling weight insulator.

 

 

 

 

 

 

 

 

 

 

 

 

While the downrigger cable is in the water, there

 

 

 

 

 

 

is a minute electrical current that flows between the

 

 

 

 

 

STOP

cable and the grounded metal boat components in

 

 

 

 

 

the water. When the cable clears the water, this

 

 

 

 

 

 

1/16"

 

current flow will stop. The Short Stop system senses

 

this interruption and turns off the motor. The trolling

 

 

 

 

 

SYSTEM

weight insulator is used to break the cable contact to

 

 

 

 

 

NOTE: It may be necessary to use two trolling

 

 

 

 

 

 

the water while the weight is still in the water. The

 

 

 

 

 

reel set screw allows the circuit path to be made through the structure of the downrigger.

weight insulators.

Stopping the weight at water level eliminates the cable strain caused by bouncing weights or weights hitting the boom end. Stopping at water level will also keep the weight from hitting the boat hull.

The Positive Ion Control System

Your boat has an electrical charge around the hull in water. If a boat is properly bonded and properly zinced, that charge should be slightly positive when measured from ground to the downrigger cable. Positive Ion Control (PIC) is the use of electricity to control that charge and its fluctuation so that it is always maintained at a specified set voltage.

The practice of setting up and maintaining a slight positive charge on fishing gear has been used by commercial fishermen for many years. This practice has enabled some fisherman to increase yield when used along with other good fishing and boating practices.

Cannon’s electric downriggers offer fishermen a big advantage in being able to stabilize and control the positive charge around their boat. Because of the Lexan® construction of the frame, Cannon downriggers are insulated from your boat’s hull charge. When the stainless steel downrigger cable is lowered into the water, the natural ionization between the cable and the boat creates a positive charge of 0.7 to 0.9 volts in saltwater and 0.3 to 0.6 volts in fresh water. This natural voltage is dependent upon salinity and mineral content of the water. Your actual voltage may vary.

14

Short Stop System

Cable

Terminator

Weight

Insulator

Image 14
Contents MAG 20DT/HS Parts Description BoomMag 20 DT New Features CannonLink DetailsMounting Accessories Downrigger Mounting on BoatsSide Rail Mounting Pedestal MountingDecks thicker than 7/16 Installing the Base on Your BoatDecks up to 7/16 thick Decks thinner than 1/4Attaching the Boom Setting Up Your DownriggerMounting the Downrigger on the Base Terminating the Downrigger Cable Cannon Uni-ReleaseSingle Rod Holder Assembly Dual Rod Holder Assembly Attaching the Rod HolderConnecting to the Battery Wiring Your DownriggerElectrical Specifications & Wiring Instructions Your Boats Electrical Condition Powering Multiple Downriggers Typical Operating TimeOperating Your Downrigger Lowering the WeightPowered Descent One speed fits all Manual Descent Fast or SlowRaising the Weight Adjusting the Depth MeterShort Stop System Short Stop SystemPositive Ion Control System Using Positive Ion Control Blowback Charts BlowbackTrouble Shooting SolutionTen Good Trolling Tips Consider special knots and swivels. aCannon Limited Warranty Authorized Service Centers CentersMAG 20 DT/HS TM Bearing Reel Shaft Nyliner 2.EA MAG 20 DT/HS/E TM Bearing Reel Shaft Nyliner 2.EA MAG 20 DT/TS TM 87 2227820 Boom END Telescopic Lexan MAG 20 DT/TS/E TM 20 9100070 Cable Leader Sleeve 2.EA