Settings
Your Detector
What To Remember While Using IntelliMute
IntelliMute works with all City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow pointing down will appear in the display. Above the activation point,
Settings
Your Detector
Select/Dim Button 
Program/Mute Button 
Set/City
Button
an arrow pointing up will appear.
Below Activation Point | Above Activation Point | ||
N W | i h | N W | i h |
If, for any reason, the unit stops sensing your engine’s revs,
IntelliMute will indicate an error and automatically turn off.
The rev point you set will be stored in the unit’s memory when power is turned off and recalled each time the power is turned on.
NOTE
The rev point must be reset if you use your detector in a different vehicle.
NOTE
When initially choosing your IntelliMute activation point, a setting of approximately 300 to 600 RPMs above idle is recommended. You can reset the activation point at any time to fit your individual preferences and driving style.
Setting The IntelliMute Activation Point
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
IntelliMute must be turned on before setting the activation point.
14 English
To Set The IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode, go to Set | Tone | Visual Display | |
IntelliMute. |
|
| |
None | Set IntelliMute | ||
| |||
|
|
| |
Press and release the Set/City button | Two (2) beeps | Press SET at | |
to begin setting IntelliMute RPMs. |
| desired RPMs… | |
|
|
| |
Rev your engine to the level you wish to | None | None | |
set. Rev the engine slightly above idle and |
|
| |
hold revs steady for two (2) seconds. |
|
| |
|
|
| |
At the desired rev level, press and | Three (3) beeps | IntelliMute Set! | |
release the Set/City button. |
|
| |
|
|
| |
Press and release either the | None | None | |
Select/Dim button to proceed to the |
|
| |
next user mode or the Program/Mute |
|
| |
button to exit the Program mode. |
|
| |
|
|
| |
Setting IntelliMute RPMs |
|
|
Set Intel... Press SET... Intelli
Mute
Set!
NOTE
If the unit is unable to sense usable pulses within three (3) seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn off. IntelliMute IntelliMute Off
Not Set
Tone | Visual Display | Intelli | |
|
| IntelliMu... | |
One (1) beep | IntelliMute not set | ||
Mute | |||
| Please try again | Please tr... | |
|
| Off | |
One (1) beep | IntelliMute Off | ||
|
15