Furuno 2167DS-BB, FAR-2167DS Armor Gasket Signal cable Flat washer Flat washer Gland nut

4.In the order shown in the figure below, pass the gland nut, flat washers (3 pcs.) and gasket onto the signal cable.

Armor Gasket Signal cable

Flat washer Flat washer Gland nut

(2)(1)

5.As shown in the figure below, fold back the armor onto flat washer (2) and insert remaining armor through flat washer (3). Cut off the part of the armor that protrudes past the flat washers

(2)and (3).

Fold back armor		Flat washer
	(3)(2)		(1)

Flat washer (2)

Cut off armor that protrudes past flat washer.

6.Lead the signal cable through its cable gland and then into the chassis. Coat the threaded part of gland nut with sealant (supplied) and then tighten the nut.

Gland for HV cable (TPYCY-1.5)

Gland for signal cable (RW-9600)

Connect shield of signal cable here.

TB Board

TB801

Coaxial

TB803 cable

TB802

Fastening coaxial cable

Antenna unit, front view

2-3