Furuno 1712 installation manual Safety Instructions

Page 3

SAFETY INSTRUCTIONS

WARNING

Do not open the equipment unless totally familiar with electrical circuits and service manual.

ELECTRICAL Only qualified personnel

SHOCK should work inside the HAZARD equipment.

Wear a safety belt and hard hat when working on the antenna unit.

Serious injury or death can result if someone falls from the radar antenna mast.

Construct a suitable service platform from which to install the antenna unit.

Serious injury or death can result if some- one falls from the radar antenna mast.

Turn off the power at the mains switch- board before beginning the installation.

Fire, electrical shock or serious injury can result if the power is left on or is applied while the equipment is being installed.

Hang the redome cover on the snap assy. after removal.

Serious injury can result if the cover falls on someone.

CAUTION

Ground the equipment to prevent electrical shock and mutual interference.

Lift the radome cover slowly.

The antenna radiator may be caught by the screw holes in the radome cover.

If you feel the radiator is caught by the screw holes, lower the cover, turn it a few degree and then lift it again.

Screw holes (4 places)

Observe the following compass safe distances to prevent interference to a magnetic compass:

 

Standard

Steering

 

compass

compass

 

 

 

 

Display

0.90 m

0.60 m

unit

 

 

 

 

 

 

 

Antenna

1.25 m

0.85 m

unit

 

 

 

 

 

 

 

i

Image 3
Contents Marine Radar Model MAY Safety Instructions Installation Materials Equipment ListsStandard Supply Optional Equipment Spare partsDisplay Unit System ConfigurationInstallation Antenna Unit InstallationMounting considerations Mounting on a platform ScrewM4X15 Mounting using the optional mounting bracket Mounting Display Unit InstallationMounting dimensions of display unit Wiring ConnectionsConnection of external equipment Sounder Nmea connectionFixing MJ-XH connector assembly Adjustment of picture AdjustmentsInstallation Check AdjustmentsTotal hours radar Has been on Has been trans Menu Mitted Heading alignmentUnit of range measurement for VRM and cursor Sweep timingAdjustments for Technicians Restoring Default Settings I/O Data ConfirmationRadar function Page Page Oct ,02 Page Page