amperage when not in use, it should be unplugged to avoid battery drain.
6.LED DISPLAY
The LED display identifies the current status of the inverter.
VOLTS IN 
: The voltage of the vehicle’s battery, Portable Power jump starter or DC power source.
VOLTS OUT 
: The voltage supplied to the device through the AC receptacle.
WATTAGE OUT 
: The power or wattage supplied to the device plugged into the inverter.
An audio alarm will sound when any of the following codes display. To stop the alarm, press the ON/OFF 
switch:
• – The inverter is not functional. See warranty and call Customer Service
• – The vehicle’s battery voltage is more than
• – The continuous load demand from the device exceeds the inverter’s wattage output.
• – The inverter is overheated and automatically turns off for a period of 1 to 3 minutes to cool. Make sure the inverter is well ventilated. It will automatically restart after it cools.
• – The vehicle’s battery voltage is less than
• – Short circuit, power surge or overload in the device.
7.IF THE INVERTER FUSE BLOWS
Your power inverter is fitted with a fuse, which should not have to be replaced under normal operating conditions. A blown fuse is usually caused by reverse polarity or a short circuit within the device or equipment being operated.If the fuse does blow:
1.Disconnect the device or equipment immediately.
2.Find the source of the problem, and repair it.
3.Install a new fuse,
4.Do not tighten the fuse cap too tight; finger tight is sufficient.
• 7 •