7. REPAIRS
The STEARNS® Cordova™ comes equipped with a repair kit that includes adhesive and several patches. This can be found in the mesh pocket and should remain with the boat. Making repairs to the inner tube of the boat may require unzipping the cover and temporarily removing the tube. Always make sure the boat is fully deflated before unzipping the cover. If there is difficulty opening the zipper, refer to the section “Care and Maintenance.” When the repair has been completed, be sure the tube is aligned properly in the boat cover and the zipper is completely closed and appropriately locked.
A
A
A = 1/2 in. (12.7mm) | A |
|
Figure 9
7.1 Repairing Small Punctures and Cuts
1.Cut a patch which is round or with round corners, at least 1/2 in. (12.7 mm) larger than the hole or cut.
2.Use water and/or mild soap to clean the area where the patch will be placed.
3.Make sure all surfaces are dry.
4.Spread a thin layer of glue on both the patch and on the damaged area and let it sit for three to five minutes or until tacky.
5.Press the patch onto the boat, making sure that no air bubbles form.
6.Apply pressure to the patch by placing weight on it. Do not peel back to see if adhesive is holding.
7.Do not inflate the boat for at least twelve hours.
7.2 Repairing Pinholes
1.Inflate the kayak. Locate the pinhole by sponging soapy water over the tube until you see air bubbles.
2.Deflate the kayak. Clean the area around the pinhole and apply a drop of adhesive to the hole once the area is completely dry.
A patch may not be necessary.
14