|
| Troubleshooting | |
Table 1 Troubleshooting Reference |
|
|
|
|
|
|
|
Problem | Possible Cause | Solution |
|
|
|
|
|
Low output voltage (96 | You are using a voltmeter that cannot | Use a true RMS reading voltmeter such as the |
|
| accurately read the RMS voltage of a | Fluke 87. |
|
| modified sine wave. |
|
|
| Low input voltage and the load is close to | Check the connections and cable to see if the |
|
| maximum allowable power. | battery is fully charged. Recharge the battery |
|
|
| if it is low. |
|
|
| Reduce the load. |
|
|
|
|
|
No output voltage. Both the Power Light and | The inverter is off. | Turn the inverter on. |
|
Fault Light are off. |
|
|
|
| No power to the inverter. | Check the wiring to the inverter and to the |
|
|
| battery selector switch (if installed). |
|
| The inverter could have been connected with | The inverter has probably been damaged. |
|
| reverse DC input polarity. | Return the unit. Damage caused by reverse |
|
|
| polarity is not covered by the warranty. |
|
|
| Information for returning the inverter is |
|
|
| provided in “Return Procedure” on page 23. |
|
|
|
|
|
No output voltage. Power Light is on. | GFCI was tripped. | Reset GFCI. |
|
|
|
|
|
17 |