Chapter 3: Replacing Pre-installed
Components
3.1Introduction
This chapter describes how to replace all the
Take note of the precautions in this section when installing your system.
3.1.1Work Area
Make sure you have a stable, clean working environment. Dust and dirt can get into components and cause malfunctions. Use containers to keep small components separated. Putting all small components in separate containers keeps them from becoming lost. Adequate lighting and proper tools can prevent you from accidentally damaging the internal components.
3.1.2Tools
The procedures that follow require only a few tools, including the following:
•A cross head (Phillips) screwdriver
•A grounding strap or an
Most of the electrical and mechanical connections can be disconnected using your fingers. It is recommended that you do not use
Chapter 3: Replacing | 43 |