This section is intended to assist the operator with the initial
DO NOT use your rammer until this section is thoroughly understood.
CAUTION:
Failure to understand the initial
See Figure 1 (Page 13) for the location of any control referenced in this manual.
Initial Start-up
The following steps outline the procedure for starting the engine:
1.Open the fuel shut- off valve by moving the fuel cock lever to the open position (Figure 6).
MT-62HS — INITIAL START-UP
2.Turn the engine ON/OFF switch (Figure 7) to the "ON" position.
Figure 7. Engine ON/OFF Switch
3. Move the throttle lever to the "IDLE" position (Figure 8).
Figure 8. Throttle Lever (Idle)
4.Incoldweather,starttherammer withthechokeleverinthe "Fully Closed" position (Figure 9). In warm weather or when the engine is warm, the unit can be started with choke halfway or completely open.
Figure 6. Fuel Shut-Off Valve (Open)
Figure 9. Choke Lever (Closed)
PAGE 16 —