Mast Set-up
1
Place the mast onto two supports (eg: two pieces of polystyrene).
Unroll the trapeze wires and fix them using a shackle to the upper hole on the mast tang (two on each side).
Trapeze wires | Trapeze wires |
Forestay
9
Shrouds
2
Unroll the shrouds and the forestay wire (with the jib halyard block) and fix them to the lower hole of the mast tang using a shackle. The shrouds go onto each side of the forestay.
3
IMPORTANT : Do not forget to attach the jib ha- lyard rope to the small single block at the end of the jib halyard wire. Tie off the jib halyard wire and rope near the base of the mast.