Hull assembly
1 |
Position the hulls in parallel with the inner sides fa- cing the ground.
Lift the right hull. One person straddles the hull to hold it in place. The other person applies the silicone sealant (for waterproofing) around the screw holes.
2 |
Take the front crossbar (with dolphin striker). Place it in its support so that the trampoline track faces the rear of the boat. Insert the two bolts. Pass your hand through the inspection port to position the nuts and washers onto the screws photo). Fasten loosely. Lift the left hull, and follow the same steps as for the right hull. Do not fully tighten the screws.
***Respect same order for the washers as assem- bled at the delivery***
3 |
Apply silicone sealant around the screw holes at the back of the hulls. Place the rear crossbar on the right side. Insert the bolts, washers and nuts as shown for the front crossbar. Do the same thing for the left side.
Once the frame has been mounted, tighten all the bolts fully and then install the lock nuts.
It is advisable to check the fastening of the bolts after the first trip out onto the water, and | 4 |
recheck these at regular intervals. |