Hobie 18 SX, 18 SE manual Trampoline Assembly

Page 6

Figure 6

10.The four outboard bolt assemblies are identical. To install, first slip the bolt through the outer end of the corner casting and down through the rail of the boat. Place the stainless steel channel over the bolt's exposed section which is under the rail. Spin the nylock nut on the bolt but do not tighten the bolt down at this time.

11. Install all four outboard bolts in the manner described in step 10. To insert the bolts in the front corner castings it will be necessary to remove the cover plates. Be careful when extracting the cover plate retaining screw. It is made of aluminum and can be galled. See Figure 6.

12.Use the hex drive to tighten the bolts. Follow this order to secure the bolts.

inboard front

Port and Starboard

inboard aft

Port and Starboard

outboard aft

Port and Starboard

outboard front

Port and Starboard

It may be necessary to repeat this sequence more than once to seat the front and back bars firmly into the saddles. Once the bolts are tight check the dolphin striker rod for looseness. If it is loose, tighten the nuts at either end of the rod where it exits the outboard section of the corner casting.

13.Replace the cover plates on the front corner castings. Be careful not to damage the retaining screw as you are installing it.

14.Re-check the cross bar after five hours of sailing. It will probably be necessary to tighten some of the bolts.

TRAMPOLINE ASSEMBLY

1.Install the aft lacing strip. Feed the lacing strip into the rear cross bar at the right just inside the hull where the track has been cut away. See Figure 7. Center it on the rear cross bar.

2.Lay the trampoline halves face down forward of the front cross bar and between the hulls. The long row of grommets should be on the inside and the short row of grommets will be up at the bow. See Figure 8

3.With the port trampoline half still face down, lead the short side (without grommets) into the front cross bar at the opening in the center of the bar and slide it over to the hull. See Figure 9

4.Pass the trampoline between the front cross bar and the dolphin striker so that it is covering the bottom of the cross bar.

Figure 7

4

Image 6
Contents Page Welcome to Hobie WAY of Life Raising the Main Sail 14-15 Setting up your Hobie12-13 Illustrations 18-25Packaging Layout Framing the Hulls Trampoline Assembly Page Page Mast Assembly Page Stepping the Mast Page Boom Installation JIB Block InstallationHobie 18 and SX18 Updates Installing the Rudder AssemblyRudder and Tiller Cross BAR Installation Pre 1987 boats Raising the Sails H18SX Downhaul Instructions Raising the Jib Dagger Boards Hobie CAT 18’ Index Mast Assembly Illustration NoIllustration No Jib Halyard Assembly Tiller Connector KitRudder Assembly Illustration No Outhaul Car AssemblyIllustration No Traveler Assembly Roller Furler AssemblyIllustration No Old style Dolphin Post Assembly Illustration No New style Dolphin Post AssemblyParts Relating to Diagram on Illustration No New style Tiller ConnectorSailing Your Hobie 18’ Turning Docking Trailering Loading Your Trailer Frame and Rollers About your Hobie 18’ Hobie