Hobie 12 manual

Page 9

r

»

Fig. 16

 

~

 

~

.

Fig 17

 

 

 

.

~

..

VI. Mainsheet Assembly

Locatemainsheet(part #16).Take oneend of the mainsheet and tie it to the small block hanging at the rear of the boomwith a bowline

(Figure 18).Run the free end through the large block of the traveler block set and then back up

to and through the .small block hanging at the rear of the boom.

Fig. 18

Now run the free end of the mainsheet for- ward along the boom. Run the line through the

circular strap attached to the boom and then run the line through the block attached to the

boomjust forward of the strap.

Continue the line forward and then down through the mainsheet block (part #32) at-

tached to the bottom of the hull behind the mast and the daggerboardslot. Tie the free end of the line in a figure 8 knot about 6 inches from the end. Shown, Figure 19.

~:::j

Fig. 19

-8-

Image 9
Contents HOLDER@12 Introduction HOLDER12@Terminology 8b Main SheetBlock 20DownhaulLine3/16x UpperMastComptip@ 16Mainsheet5/16x GudgeonsPlugs II. Traveler Assembly PadeyeasshowninLine,from the outsideof the HOLDER@ WInsert the top sectionof the mast into Page Outhaul, Downhaul and Vang Assembly IV. Boom AssemblyGooseneckFigure12.Then take the clew ~ .Youare now readyto connectthePage VII. Rudder and DaggerboardSpecial Balancmg the Boat Mainsheet,thengrabontoeither the gunnelor Basic SailingIX. Trailering Knots to Use Sendin your warranty cardBasic Sailing ChangingDirection~!DER