w w w . e l a t i o n l i g h t i n g . c o m
S A F E T Y I N S T R U C T I O N S
The PIXEL BAR 40™ is an extremely sophisticated piece of electronic equipment. To guarantee a smooth operation, it is important to follow the guidelines in this manual. The manufacturer of this device will not accept responsibility for damages resulting from the misuse of this device due to the disregard of the information printed in this manual.
•For proper operation, only qualified and certified personnel should perform installation of this device. DO NOT attempt installation and/or operation without proper knowledge how to do so. Any modifications to this device will void the original manufactures warranty and increase the risk of damage and/or personal injury.
•Air inlets must remain clean and never blocked. Device must be installed in a location with adequate ventilation. Allow approx. 6” (15cm) between this device and other devices or a wall for proper cooling.
•Always disconnect from main power source before performing any type of service and/or cleaning procedure. Only handle the power cord by the plug end, never pull out plug by tugging wire the cord.
•DO NOT remove or break off the ground prong from the power cord.
•DO NOT operate device if the power cord has become frayed, crimped and/or damaged. If the power cord is damaged, replace it immediately with a new one of similar power rating.
• N E V E R O P E N D E V I C E W H I L E I N U S E !
• D O N O T C O N N E C T T H I S D E V I C E T O A D I M M E R P A C K !
• This device is designed for INDOOR / DRY LOCATIONS ONLY.
• DO NOT operate device in areas subject to extreme vibrations or bumps.
• NO FLAMMABLE MATERIALS close to this device while operating, to prevent any fire hazard.
• DO NOT permit operation by persons who are not qualified for operating this type device. Most damages
are the result of operations by nonprofessionals.
• Please use the original packaging and materials to transport this device in for service
7 | PIXEL BAR 40™ User Manual 1.0 |