![](/images/new-backgrounds/1135589/13558933x1.webp)
SETUP
CONNECTIONS
When connecting the vibrator motor to flex shaft and heads, use only the combination shown below in Table 6.
Table 6. Shaft Sizes
Model | Shaft | Head | Max. Shaft | |
Length | ||||
|
|
| ||
CV1A | FSN | 900HD | 21 ft. | |
1000HD | ||||
|
|
| ||
CV2A |
| 1400HD | 20 ft. | |
FS | 1700HD | |||
| ||||
CV2B |
|
| ||
| 2100HD | 21 ft. | ||
|
| |||
|
|
|
| |
CV3A |
| 1400HD |
| |
FS | 1700HD | 35 ft. | ||
CV3B | 2100HD | |||
|
| |||
|
| 2600HD |
|
QUICK |
| |
DISCONNECT | SPINDLE AND | |
KNOB | ||
CORE ARE ATTACHED | ||
| ||
| (1 PIECE) |
attaching Vibrating Head To flex-Shaft
1.Locate appropriate coupler and spindle for desired
2.Apply a ring of anaerobic sealant (Loctite™ No. 271) to flexshaft threads as shown in Figure 4.
3.Insert coupler and spindle into flexshaft as shown in Figure 4.
4.Attach vibrator head onto flexshaft as shown in Figure 4.
5.Use a wrench and tighten vibrator head securely to flexshaft. Threads are
NOTICE
All flexshaft cores have been lubricated (greased) at the factory and are ready for use.
NOTICE
FS series flexshafts use a spindle that is permanently attached to the wire core.
MOTOR
HREADT PIP LOCTITE™271
VIBRATOR
END
QUICK
HEAD
DISCONNECT
COUPLER
FSN/FS SERIES
FLEXIBLE SHAFT
Figure 4. Attaching Vibrating Head to Flexshaft
cv sERIES vibrator motor • operation and parts manual — rev. #0 (04/30/13) — page 17