Cisco Systems 1700 appendix Error Reporting, Destinationfilename

Appendix B ROM Monitor

	Console Download
Argument	Description
y	Optional. Sets the router to perform the download
	using ymodem protocol. Default is xmodem protocol.
	The protocols differ as follows:
	• The xmodem protocol supports a 128-block
	transfer size, whereas the ymodem protocol
	supports a 1024-block transfer size.
	• The ymodem protocol uses 16-bit CRC error
	checking to validate each packet. Depending on
	the device that the software is being downloaded
	from, this function might not be supported by the
	xmodem protocol.
r	Optional. Image is loaded into DRAM for execution.
	Default is to load the image into Flash memory.
x	Optional. Image is loaded into DRAM without being
	executed.
destination_file_name	The name of the system image file or the system
	configuration file. In order for the router to recognize
	it, the name of the configuration file must be
	router_confg.

Error Reporting

Because the ROM monitor console download uses the console to perform the data transfer, error messages are displayed on the console only when the data transfer is terminated.

If an error does occur during a data transfer, the transfer is terminated, and an error message is displayed. If you have changed the baud rate from the default rate, the error message is followed by a message telling you to restore the terminal to the baud rate specified in the configuration register.

	Cisco 1700 Series Router Software Configuration Guide
78-5407-03		B-11