4.Select Tracking Method, and then press the [MENU] key.
5.Select method desired.
6.Press the [END] key several times to close the menu.
Tracking target lock mark
1.Operate the trackball to place the trackball mark on the fish school you want to track.
2.Press the [TARGET LOCK] key to light the lamp above it.
The target lock mark (
) appears on the fish school and tracking begins.
Tilt angle is automatically changed to keep the target lock mark location within the sonar beam.
3. To stop tracking, press the [TARGET LOCK] key again.
Note 1: If the target goes out of the picture or the tilt angle is greater than 60 degrees the lamp above the [TARGET LOCK] key flashes to call your attention.
Note 2: Target lock position and data are calculated according to tilt angle.
Note 3: The bearing mark moves to the target lock mark loca- tion when target lock becomes active. Bearing to the target lock mark is shown.
Note 4: Target lock is temporarily disabled when the distance to the tracked fish school is less then 40 m. It is resumed once the distance becomes more than 40 m.
Note 5: The target lock works up to a tilt angle of 60 degrees. In the drawing below, the tilt angle is fixed at 60 degrees between B and C. During this period, however, calculation is continu- ously being performed. When own ship comes to point C, target lock is resumed.
Depth
ABCD
60° 60°