Eagle Electronics 245DS To adjust sensitivity in Auto Mode, To adjust sensitivity in Manual Mode

Page 46

Sensitivity set to manual mode (left). Sensitivity scroll bar (right).

You can change the sensitivity level whether you are in Auto Sensitivity mode or Manual Sensitivity mode. The adjustment method works the same in both modes, but gives you slightly different results.

To adjust sensitivity in Auto Mode:

Repeatedly press MENU until the SENSITIVITY menu appears. Make sure sen- sitivity is set to Auto, then press MENU UP to access the sensitivity scroll bar. Press ↑ to increase the sensitivity, ↓ to decrease it. When it is set at the desired level, press PWR to clear the menu. If you reach the maxi- mum or minimum sensitivity level, a tone sounds alerting you to the limits.

To adjust sensitivity in Manual Mode:

If you want to change the sensitivity in Manual Mode, turn off Auto Sensitivity. Repeatedly press MENU until the SENSITIVITY menu appears. Press ↓ to select MANUAL, then press MENU UP to access the sensitivity scroll bar. Press ↑ to increase sensitivity, ↓ to decrease it. When it is set at the desired level, press PWR to clear the menu.

42

Image 46

Contents FishEasy→ 245DS FishEasy→ 245DS Portable SeaFinder→ 245DS Eagle Electronics Box Catoosa, OK USA Table of Contents Troubleshooting Introduction GeneralSonar sounding Back-up memorySonar Automatic rangingDual Search Transducer How Sonar WorksPreparations Installation Recommended Tools and supplies Selecting a Transducer LocationPad Deadrise less than Strakes How low should you go? Shoot-Thru-Hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Assemble transducer and bracket Transom Bottom Hull Flat-bottom hullDeep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation Testing Determines Best Location Second bottom True bottom Manual range setting Shoot-Thru-Hull Installation Power Connections permanent mount only To unit Red wire with Amp fuse Black wire Volt battery Page 107.5 82.7 156 Using the Quick Release Mounting Bracket Mount the sonar slide the unit onto the bracket from above Portable Sonar Installation Installing the Batteries Mounting the Unit Page Portable transducer installed on boat transom Portable Transducer Storage Page Operation Keyboard BasicsMenus MemoryUP & Down Arrows ↑ ↓ Display Full Chart Depth RangeZoom Zoom feature turned off left. Zoom turned on right Sensitivity To adjust sensitivity in Auto Mode To adjust sensitivity in Manual ModeGrayline Grayline scroll bar Chart Speed Frequency Fish I.D Fish arches Fish I.D. symbols Fish Alarm AlarmsFishTrack Depth Alarms Shallow AlarmDeep Alarm Battery Alarm Noise Rejection and ASP Depth Display To display DepthTemperature Display Voltage To display TemperatureTo display battery voltage BacklightContrast SimulatorSoftware Information Reset OptionsSet Language To select a languagePage Page Unit wont turn on Unit turns on only in simulator modeUnit freezes, locks up, or operates erratically Page No fish arches when the Fish I.D. feature is off NoisePage Eagle Electronics How to Obtain Service… Not toll-freeAccessory Ordering Information for all countries Visit our web site