Eagle Electronics 245DS manual Depth Alarms, Shallow Alarm

Page 54

To turn on Fish I.D., repeatedly press MENU until the FISH ID menu ap- pears. Press to select ON, then press PWR. Repeatedly press MENU un- til the FISH ALARM menu appears. Press to select ON, then press PWR.

To turn on Fish I.D., repeatedly press MENU until the FISH ID menu ap- pears. Press to select ON, then press PWR. Repeatedly press MENU un- til the FISH ALARM menu appears. Press to select ON, then press PWR.

To turn off fish alarm repeatedly press MENU until the FISH ALARM menu appears. Press to select OFF, then press PWR to clear the menu.

Fish Alarm menu.

Depth Alarms

The depth alarms are triggered only by the bottom signal. No other echoes will activate these alarms. The depth alarms consist of a shal- low and a deep alarm. The shallow alarm sounds an alarm tone when the bottom goes shallower than the alarm's setting. The deep alarm sounds a tone when the bottom goes deeper than its setting. Both alarms adjust the same way, although through different menus.

Shallow Alarm

To set the shallow alarm depth, repeatedly press MENU until SHALLOW ALARM appears.

50

Image 54
Contents FishEasy→ 245DS FishEasy→ 245DS Portable SeaFinder→ 245DS Eagle Electronics Box Catoosa, OK USA Table of Contents Troubleshooting Introduction GeneralSonar sounding Back-up memorySonar Automatic rangingDual Search Transducer How Sonar WorksPreparations Installation Recommended Tools and supplies Selecting a Transducer LocationPad Deadrise less than Strakes How low should you go? Shoot-Thru-Hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Assemble transducer and bracket Transom Bottom Hull Flat-bottom hullDeep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation Testing Determines Best Location Second bottom True bottom Manual range setting Shoot-Thru-Hull Installation Power Connections permanent mount only To unit Red wire with Amp fuse Black wire Volt battery Page 107.5 82.7 156 Using the Quick Release Mounting Bracket Mount the sonar slide the unit onto the bracket from above Portable Sonar Installation Installing the Batteries Mounting the Unit Page Portable transducer installed on boat transom Portable Transducer Storage Page Operation Keyboard BasicsMemory MenusUP & Down Arrows ↑ ↓ Display Full Chart Depth RangeZoom Zoom feature turned off left. Zoom turned on right Sensitivity To adjust sensitivity in Auto Mode To adjust sensitivity in Manual ModeGrayline Grayline scroll bar Chart Speed Frequency Fish I.D Fish arches Fish I.D. symbols Alarms Fish AlarmFishTrack Depth Alarms Shallow AlarmDeep Alarm Battery Alarm Noise Rejection and ASP Depth Display To display DepthTemperature Display Voltage To display TemperatureTo display battery voltage BacklightContrast SimulatorSoftware Information Reset OptionsSet Language To select a languagePage Page Unit turns on only in simulator mode Unit wont turn onUnit freezes, locks up, or operates erratically Page No fish arches when the Fish I.D. feature is off NoisePage Eagle Electronics How to Obtain Service… Not toll-freeAccessory Ordering Information for all countries Visit our web site