Eagle Electronics 245DS manual Shoot-Thru-Hull Installation

Page 25

Shoot-Thru-Hull Installation

1.Make sure the area is clean, dry and free of oil or grease, then sand both the inside surface of the hull and the face of the transducer with

100grit sandpaper. The sanded hull area should be about 1-1/2 times the diameter of the transducer. The surface of the hull must be flat so the entire transducer face is in contact with the hull prior to bonding. After sanding, clean the hull and transducer with rubbing alcohol to remove any sanding debris.

Spread epoxy here

Sand this surface

Orient the Skimmer with the nose facing the bow of the boat.

To bow

Epoxy transducer to hull.

WARNING:

Use only the epoxy available from LEI. It has been for- mulated to work with these installation procedures. Other epoxy types may be too thin or may not cure to the right consistency for optimum transducer perform- ance.

21

Image 25

Contents FishEasy→ 245DS FishEasy→ 245DS Portable SeaFinder→ 245DS Eagle Electronics Box Catoosa, OK USA Table of Contents Troubleshooting General IntroductionSonar Back-up memorySonar sounding Automatic rangingHow Sonar Works Dual Search TransducerPreparations Installation Selecting a Transducer Location Recommended Tools and suppliesPad Deadrise less than Strakes How low should you go? Shoot-Thru-Hull vs. Transom Mounting Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Assemble transducer and bracket Transom Bottom Hull Flat-bottom hullDeep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation Testing Determines Best Location Second bottom True bottom Manual range setting Shoot-Thru-Hull Installation Power Connections permanent mount only To unit Red wire with Amp fuse Black wire Volt battery Page 107.5 82.7 156 Using the Quick Release Mounting Bracket Mount the sonar slide the unit onto the bracket from above Portable Sonar Installation Installing the Batteries Mounting the Unit Page Portable transducer installed on boat transom Portable Transducer Storage Page Keyboard Basics OperationMenus MemoryUP & Down Arrows ↑ ↓ Display Depth Range Full ChartZoom Zoom feature turned off left. Zoom turned on right Sensitivity To adjust sensitivity in Manual Mode To adjust sensitivity in Auto ModeGrayline Grayline scroll bar Chart Speed Frequency Fish I.D Fish arches Fish I.D. symbols Fish Alarm AlarmsFishTrack Shallow Alarm Depth AlarmsDeep Alarm Battery Alarm Noise Rejection and ASP To display Depth Depth DisplayTemperature Display To display battery voltage To display TemperatureVoltage BacklightSimulator ContrastSet Language Reset OptionsSoftware Information To select a languagePage Page Unit wont turn on Unit turns on only in simulator modeUnit freezes, locks up, or operates erratically Page Noise No fish arches when the Fish I.D. feature is offPage Eagle Electronics Not toll-free How to Obtain Service…Accessory Ordering Information for all countries Visit our web site