SAFETY INSTRUCTIONS
Safety Instructions for the Installer
WARNING
Do not work inside the equipment unless totally familiar with electrical circuits.
Hazardous voltage which can shock, burn or cause serious injury exists inside the equip- ment.
Turn off the power at the mains switchboard before beginning the installation. Post a sign near the switch to indicate it should not be turned on while the equip- ment is being installed.
Fire, electrical shock or serious injury can result if the power is left on or is applied while the equipment is being installed.
CAUTION
Ground the equipment to prevent electrical shock and mutual interference.
Confirm that the power supply voltage is compatible with the voltage rating of the equipment.
Connection to the wrong power supply can cause fire or equipment damage. The voltage rating appears on the label at the rear of the display unit.
Use the correct fuse.
Use of a wrong fuse can cause fire or equipment damage.
Keep the following compass safe distance.
Standard Steering
Display Unit | 0.98 m | 0.74 m |
When handling the transducer cable, keep in mind the following points.
•Keep the cable away from oil and fuel.
•Keep the cable away from the place where it may be damaged during the installation.
•Do not paint the cable.
The sheath of the transducer cable is made of chlorophrene rubber (or vinyl chloride). Therefore, do not paint the sheath with organic liquid (such as toluene) since it may harm the sheath.
i